Owner`s manual

17
AM (all AM Presets are cleared)
FM (all FM Presets are cleared)
All (all AM and FM Presets are cleared).
Note: The Presets are cleared when the Setup
Mode is exited.
3. Proceed to the next Setup Menu Item or press the
MONO/SETUP Push-button to exit the Setup
Mode. “How to operate the Tuner” starts on page
20.
2. Rotate the TUNE/ADJUST Control to select the
correct setting.
3. Proceed to the next Setup Menu Item or press the
MONO/SETUP Push-button to exit the Setup
Mode. “How to operate the Tuner” starts on page
20.
Clear Presets
The MR87 AM/FM Tuner has three different Tuning
Modes. One of the Tuning Modes is Preset Tuning,
where favorite stations are entered into memory for
quick recall. Any preset station may be removed from
memory at any time. There are times when it may be
desirable to remove from memory all or some of the
preset stations. To accomplish this perform the follow-
ing steps:
1. Press the MONO/SETUP Push-button until the
Setup Mode is active. Then rotate the PRESET/
MENU Control to select Setup Menu item “SET-
UP: PRESETS”. Refer to figures 14 thru 17.
2. Rotate the TUNE/ADJUST Control to select one
of four choices:
NONE (default setting, No Presets are cleared)
Figure 14
SETUP: PRESETS
CLEAR PRESETS: NONE
Dial Brightness
The brightness level of the Dial may be changed from
the default setting. To change the brightness perform
the following steps:
1. Press the MONO/SETUP Push-button until the
Setup Mode is active. Then rotate the PRESET/
MENU Control to select Setup Menu item
“SETUP: DIAL BRIGHTNESS: 15 ”. Refer to
figure 18.
Figure 13
SETUP: DEEMPHASIS
50uS
Figure 12
SETUP: DEEMPHASIS
75uS
Figure 15
SETUP: PRESETS
CLEAR PRESETS: AM
Figure 16
SETUP: PRESETS
CLEAR PRESETS: FM
Figure 17
SETUP: PRESETS
CLEAR PRESETS: ALL
2. Rotate the TUNE/ADJUST Control to select the
desired brightness. The range of adjustment is
from 0 to 20.
3. Proceed to the next Setup Menu Item or press the
MONO/SETUP Push-button to exit the Setup
Mode. “How to operate the Tuner” starts on page
20.
Figure 18
SETUP: DIAL
BRIGHTNESS: 15
Information Display Brightness
The brightness level of the Front Panel Information
Display may be changed from the default setting. To
change the brightness perform the following steps:
1. Press the MONO/SETUP Push-button until the
Setup Mode is active. Then rotate the PRESET/
MENU Control to select Setup Menu item
“SETUP: DISPLAY BRIGHTNESS: 3”. Refer to
figure 19.
2. Rotate the TUNE/ADJUST Control to select the
desired brightness. The range of adjustment is
from 1 to 4.
3. Proceed to the next Setup Menu Item or press the
MONO/SETUP Push-button to exit the Setup
Mode. “How to operate the Tuner” starts on page
20.
Information Display Auto Fade
The Front Panel Information Display Auto Fade
Feature may be activated by performing the following
steps:
1. Press the MONO/SETUP Push-button until the
Figure 19
SETUP: DISPLAY
BRIGHTNESS: 3