WS500 In-Wall Loudspeaker System Installation Guide McIntosh Laboratory, Inc.
Important Safety Instructions WARNING - TO REDUCE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL. IMPORTANT SAFETY INSTRUCTIONS! PLEASE READ THEM BEFORE OPERATING THIS EQUIPMENT. General: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Warning: To reduce risk of fire or electrical shock, do not expose this equipment to rain or moisture.
Table of Contents Important Safety Instructions ��������������������������������������� 2 Thank you from all of us at McIntosh ��������������������������� 2 Make a Note ������������������������������������������������������������������ 2 Tools Needed ����������������������������������������������������������������� 3 Parts Included ��������������������������������������������������������������� 3 Ready To Perform ��������������������������������������������������������� 3 Making a Hole ���������������������
(7.62m) use at least 16AWG wire. For runs under 50 feet (15.24m) use at least 14AWG, and for longer runs up to 100 feet (30.48m) use 12AWG. 12AWG, being the larger wire, can be used in all the above cases if desired. 1. Pull enough speaker wire through the opening in the Frame to connect to the WS500. 2. Run the speaker wire through the Airtight Connector on the Box that will fit on the rear of the Baffle. The Airtight Connector can be positioned as the top or the bottom of the Box. 3.
W LOUDSPEAKER PRODUCTS FIVE YEAR LIMITED WARRANTY elcome to the family of McIntosh owners. This is the Warranty for your new McIntosh Loudspeaker Product (the “Speaker”). Your Speaker has been designed to give many years of trouble-free performance. Nonetheless, failures do sometimes occur even with equipment as wellbuilt as McIntosh’s.
Specifications Drivers Two 6-1/2 inch Woofers Two 50mm Inverted Dome Midranges One 20mm Titanium Dome Tweeter Impedance 4 Ohm Nominal Frequency Response 80Hz - 20kHz ±3dB (Anechoic Response) Sensitivity 86dB (2.8V/1m equivalent) Crossover Frequencies 350Hz 2,500Hz Power Handling 250 Watts Maximum Operating Temperature 41o-95oF 5o-35oC Operating Humidity McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, NY 13903 30-85% Overall Dimensions Height is 23.5 inches (59.7cm) Width is 14 inches (35.