Installation Guide

4
(7.62m) use at least 16AWG wire. For runs under 50 feet
(15.24m) use at least 14AWG, and for longer runs up to
100 feet (30.48m) use 12AWG. 12AWG, being the larger
wire, can be used in all the above cases if desired.
1. Pull enough speaker wire through the opening in the
Frame to connect to the WS500.
2. Run the speaker wire through the Airtight Connector
on the Box that will t on the rear of the Bafe. The
Airtight Connector can be positioned as the top or the
bottom of the Box.
3. Loosen the Loudspeaker Binding Posts on the rear of
the Bafe to reveal a hole for the speaker wire.
4. Insert the wire making sure no loose strands are
exposed. Connect the positive speaker wire to the red
terminal and the negative to the black terminal.
5. Tighten the Binding Posts.
Pung it in the Wall
1. The Bafe will sit inside the Box.
2. Place Fiberglass Packing between the Bafe and the
Box and then place the Bafe in the Box.
3. Place the Box and the Bafe inside the Frame.
4. Use the 6 supplied #10-24 x 1-1/2 inch Screws to
secure the Bafe and Box to the Frame. Place a #8
Bafe Washer on each screw before fastening. Use
care to hold the Bafe in place until there are at least
two screws installed.
5. Place the Grille in front of the Bafe. It is held on by
magnets.