Owner's Manual

How to Connect

Power Amplifier

6.6

Spade Lug or Wire Connections:

11. Referring to the illustration on the next page, con-

nect the Loudspeaker hookup cables to the XR50

Negative (-) Input Terminal and Positive (+) Input

Terminal. Insert the spade lug connector or pre-

pared

section

of the

cable

end

into

the

terminal side access hole, and tighten the termi-

nal cap until the cable is firmly clamped into the

terminals so the lugs or wire cannot slip out. Refer

to figures 15 and 16.

Note: It is important to maintain the correct polar-

ity at both ends of the Loudspeaker cables.

11. Connect the other end of Loudspeaker cables com-

ing from the XR50 Negative (-) Input Terminal to

the Left Channel COM (-) Output Terminal of the

Amplifier.

12. In a similar manner, connect the Loudspeaker

cables coming from the XR50 Positive (+) Input

Terminal to the Left Channel 8 ohm (+) Output

Terminal of the Amplifier.

13. Connect the second XR50 Loudspeaker to the Am-

plifier in a similar manner.

14. Connect the second XR50 Loudspeaker in a

similar manner to the Amplifier Right Channel

Terminals.

Figure 15

Figure 16

XR50 Right Channel

XR50 Left Channel