Installation manual

Page 24

Scanning All Channels

To Scan All Channels:

1. Press Menu action key to display top level

menu selection; Send DSC messages.

2. Use the Scroll keys to display the

Channel scanning menu.

3. Press Select.

4. The first option displayed in the Channel

scanning menu is Run scan program.

Press Select.

5. The first option displayed in the

Run scan program menu is Scan: ALL.

Press Select.

6. The scan program is now running. The

Scan: ALL run screen is displayed.

The channel is incremented every x ms,

where x is the dwell time, and every 1.8

seconds the Priority Channel (normally Channel 16) is monitored for activity. If

activity is detected on any channel the radio will stop scanning and channel on

which activity was selected will remain selected. After 5 seconds of no activity on

the channel, the radio will resume scanning.

NOTE: During channel scan, channels with a 1W maximum transmission power

requirement cause the radio to select 1W power for those channels. This is to allow

for the possibility that you may accidentally press PTT, when channel 75 or 76 is

selected, as these are defined as restricted power channels.

Send DSC Messages 

Select Exit

Channel scanning 

Select Exit

50°56'N at:08:41

001°34'E UTC

Pos

Channel scanning

Run scan program 

Select Back

Run scan program

Scan:

ALL

Select Back

Scan:ALL run

Stop

27 Back