Installation manual

Appendix Page 6
User Initiated Self-Tests
Type of Test / Error Message Probable Cause / Solution
If this test is run within 2 minutes of power-up
and no source of GPS derived positional
information, via the NMEA port, is found the
display message is ‘Pos update not found’.
(Please check the GPS connections.)
If the radio received a valid NMEA
command, but no more GPS information
within 1 minute after that command then the
radio assumes the GPS connection is lost.
Please check your GPS connections.
(Press OK to continue)
Position information is more than 4 hours
old.
(For safety reasons you should re-enter your
position, or if GPS is available, connect your
GPS unit.)
The radio synthesiser lock could not be
confirmed. This can cause problems with
transmission and reception.
Operation of the radio is inhibited.
(If the fault persists after the radio is
switched off and on again, then it will be
necessary to consult a Service Agent.)
A fault was found when checking data in the
processor registers.
Operation of the radio is inhibited.
(If the fault persists after the radio is
switched off and on again, then it will be
necessary to consult a Service Agent.)
Error detected
Synth out of lock
See operators manual
OK
Pos update not found
Menu
16 Update
Pos update not found
OK
Error detected
Register invalid
See operators manual
OK
Position too old
OK