Installation manual

Appendix Page 7
Operational Error Messages (1)
Type of Test / Error Message Probable Cause / Solution
Range check: MMSI number.
An attempt was made to save an MMSI
number of less than 9 digits.
(Please enter 9 digits.)
Range check: Ship MMSI as default.
An attempt was made to save a default
MMSI number.
(Please enter a valid MMSI number.)
Range check: Group MMSI.
An attempt was made to save a Coast
Station MMSI into a Group MMSI memory.
(Please remove one of the leading ‘0’s.)
Out of range: Time / Date / Timezone
(offset). If invalid Time, Date or Timezone is
entered the radio will display ‘Invalid Time /
Date / Timezone’
(Please re-enter correct value.)
Out of range: possible messages:
Invalid character’ ,
‘Latitude->Degrees’, ‘Latitude->Minutes’,
‘Latitude->Seconds’, ‘Longitude->Degrees’,
‘Longitude->Minutes’, ‘Longitude->Seconds’.
(Please re-enter correct value.)
Scan Program empty.
An attempt was made to run an empty Scan
Program.
(Please use Edit Scan Program to enter
channels into the Scan Program.)
Scan Program full.
An attempt was made to add more than 30
channels into a Scan Program.
(Do not enter more than 30 channels or re-
edit the Scan Program.)
Directory: an attempt was made to enter
more than 50 names.
(Do not enter more than 50 names or erase
an existing entry to proceed.)
Invalid time
Out of range!
Scan program empty
Scan program full
Erase before insert
Group MMSI number
can not be
a coast station
Length of stn MMSI
must be 9 digits
Ship MMSI number
can not be
000000000