Installation manual

Page 26
Hole size
to fit #10 screw:
3.5mm
Trunnion mounting the display
The standard bulkhead mounting U-Bracket can be used to mount the NAV-7 above
or below a horizontal (or near horizontal) surface.
Drilling drawing (mm)
Select hole size to suit method of fixing mountings –
clear or tapped holes.
Rear view of trunnion bracket assembly
Ensure that rubber washers are fitted between
the trunnion bracket and the plastic enclosure.
Tilt the display to the correct viewing angle.
Tighten the two thumbwheels.
Mounted dimensions:
Height: 150 mm
Width: 270 mm
Depth: 120 mm (over connectors)