Owner's manual

CLEANING GUIDELINES

Proper cleaning and regular inspection is essential to keep the toilet lift operating at

maximum efficiency and providing the best possible safety for each user of this

product. If the toilet lift is not cleaned on a regular basis, the top plate of the unit

could prematurely rust due to the highly corrosive nature of urine. The toilet lift unit

must be maintained and cleaned accordingly.

Do not use abrasive cleaners, brushes, or scouring pads to clean the toilet lift unit.

For cleanin

1. First remove the toilet lift unit from around the toilet as follows:

• Remove 110V plug from the wall

• Slide toilet lift unit away from toilet

2. Clean the toilet lift

•Wipe down all metal surfaces (top plate, linkage bars, and frame) using a soft cloth

or non-abrasive sponge with a mild cleanser such as, soap and water or other mild

household cleaners to remove any contaminants.

•Wipe dry all the cleaned surfaces of the unit using a dry soft cloth.

•Keep the unit in the lowere

d position when cleaning the actuator, so that the

actuator cannot be degreased causing premature failure. Clean the actuator as

suggested above.

3. After cleaning the toilet lift unit and the toilet, replace the toilet lift unit as follows:

• Return unit around toilet

• Plug unit back into 110V wall socket

• Use the hand pendant to check the alignment of the unit to the toilet. Refer to p.

16 for alignment instructions.

INSPECTIONS

Inspect the unit to make sure it is level to the floor. Check to make sure the unit is

properly aligned to the toilet. Use the hand pendant to cycle the unit from the seated

position to the standing position, making sure it is free from any obstructions.

SHIPPING CONDITIONS EFFECT ON TOILET LIFT

If the box is exposed to weather, no hazards exist as a result of packaging failure due

to excessive weather (i.e. being exposed to rain, snow or extreme humidity).

If packaging fails due to destructive forces, check all connections on the frame to

make sure the product did not suffer any physical damage. Other than extreme cases,

no structural damage, other than cosmetic, should occur if the packaging fails