Specifications

IM 1049-4 / Page 5 of 36
3. Removetheaccesspaneltothefanmotorbyloosening
thetwo(2)screwsatthebottomholdingthepanel(Figure
3).Removethepieceofinsulationatthebottomonthe
sideofthebottompanel.
4. Iftheunitbeingconvertedisinstalledandhasbeen
operating, discharge the capacitor. Release the wire
clip shown in Figure 4toprovideslackinthewires.If
necessary remove the wire tie to provide additional free
wire length (Figure 4).
Figure 4: Discharge capacitor and release wire clip
Release wire clip to
provide slack in
wiring
Discharge
Capacitor
Capacitor
5. Remove the screws securing the fan discharge panel
assembly(Figure 3).
Air Discharge Conversion
Unitsizes007thru060arestockedasstraightdischarge.A
straightdischargeunitmaybeconvertedtoanenddischarge
bydoingthefollowing:
Note: The information covered in this section of the blower
assembly orientation is typical of Daikin McQuay
units. Regardless, if you are changing end to straight
or straight to end the blower assembly has to turn 90
degrees and simultaneously rotate 180 degrees to
achieve the proper orientation. Not all Daikin McQuay
units will have the same air discharge location but
will have the same general results when following the
instructions.
DANGER
Hazardous Voltage!
Disconnect all electric power including remote dis-
connects before servicing. Failure to disconnect
power before servicing can cause severe personal
injury or death.
Sharp edges can cause personal injury. Avoid contact with
them. Use care and wear protective clothing, safety glasses and
gloves when handling parts and servicing heat pumps.
CAUTION
1. Turnoffpowertotheunitatthebreakerbox.
2. Removethetoppanelbyremovingthescrewsaround
theperimeterofthetopsecuringittothelowercabinet
(Figure 3).
Note: Retain all screws for reinstalling.
Figure 3: Remove top and access panel to fan motor
Remove screws around
the perimeter of top
Loosen two (2) screws at
bottom of access panel to
fan motor
Remove Top
Remove Access
Panel to Fan
Motor Assembly
Fan Discharge Panel Assembly
(Bottom-Horizontal Orientation)