Instruction manual

52 KOMAC00607-09EN
Figure 16, Navigation, Part C
V
iew/Set Unit
A
WM Setup (view/set unit)
Status/Settings
>
Apply Changes R/W
Set-Up
>
DHCP R/W
Temperatures
>
Actual IP Address R
Date/Time/Schedules
>
Actual Mask R
Power Conservation
>
Actual Gateway R
LON Setup
>
Given IP Address R/W
BACnet IP Setup
>
Given Mask R/W
BACnet MSTP Setup
>
Given Gatewa
y
R/W
Modbus Setup
>
AWM BSP R
AWM Setup
>
Design Conditions (view/set
Design Conditions
>
Evap Entering Water Temp @ R
Alarm Limits
>
Evap Leaving Water Temp @ R
A
larm Limits (view/set unit)
Menu Password
>
Low Pressure Hold Setpoint R
Low Pressure Unload Setpoint R
V
iew/Set Circuit
>
Menu Password (view/set
Status/Settings
>
Password Disable R/W
Compressor
>
Status/Settings (view/set
Status Circuit 1
Time Until Restart
>
Circuit Status R
Compressor 1 Cycle Time R Circuit Mode R/W
Compressor 2 Cycle Time
R Circuit Capacity R
Compressor 3 Cycle Time
R
Compressor 4 Cycle Time R Status Circuit 2
>
Status Circuit 3
>
Alarms
>
Status Cricuit 4
>
Alarm Active
>
Alarm Log
>
Compressor (view/set circuit)
Compressor 1 Circuit 1
Scheduled Maintenance
Next Maintenance Month/Yea
r
R/W Run Hours R
Service Support Reference R Number Of Starts R
A
larm Active (Alarms)
About This Chiller Active Alarm 1 R
Model Numbe
r
R … R
G. O. Number R Active Alarm n R
Unit Serial Number R Acknowledge All R/W
Starter Model Number(s) R
Starter Serial Number(s) R
A
larm Log (Alarms)
Firmware Version R Alarm Entry 1 R
Application Version R
… R
Application GUID R
Alarm Entry 25 R
HMI GUID R
OBH GUID R
Note: Parameters with an “*” are available without entering a password.