Specifications

10 McQuay IM 846
Optional Occupancy Detection Equipment Operation
SD200-001 Occupancy Sensor
The SD200-001 occupancy sensor (Figure 11) serves as a
master sensor for a guest room HVAC management system.
The sensor provides HVAC operation according to occupancy
status, as well as door/window switch monitoring, selectable
high/low temperature setback, form-C output, slave sensor
connectivity, and a five minute door open HVAC shut-off.
Note – To use this configuration, the jumper to JP3 is removed to
allow setback input.
Note – An optional door and/or window switch (Figure 11) and
slave sensor can be added for use with the SD200-001
sensor.
Operation
In an occupied mode, the SD200-001 occupancy sensor
(Figure 11) and door switch use advanced microprocessor
logic to determine occupancy. A door open signal will initiate
occupancy status detection. If the sensor determines that a
room is occupied, it will allow normal HVAC control. The
sensor will wait for another door open signal before
determining occupancy again.
In an unoccupied mode, the sensor continually monitors the
room. Any occupancy detection will set the operation to
occupied mode.
Figure 11: Optional equipment configuration #2