Specifications

4
FIGURE 4
SEAL STRIP
END VIEW
OUTSIDE AIR RAIN HOOD
(UPPER LEFT SIDE)
EXHAUST AIR RAIN HOOD
(LOWER LEFT SIDE)
A1005-01
FIGURE 5
A1006-01
STEP 16:
Remove the BLOWER MOTOR ACCESS PANEL (SEE
FIGURE 5).
STEP 17:
Connect the j DISCHARGE AIR SENSOR to wires 51
and 52 located in the blower motor compartment.
NOTE:
Mixed air sensor should be secured with the included wire
tie to avoid entanglement with the blower and direct
contact with any sheet metal surfaces.
STEP 18:
Replace the BLOWER MOTOR ACCESS PANEL.
STEP 19:
Upon start-up check the economizer sequence of
operation using the steps provided in these instructions.
After testing unit operation and setting outside air damper
minimum position, replace RETURN COVER with
remaining screws.
WIRE TIE
INDOOR MOTOR

EXHAUST AIR RAIN HOOD ASSEMBLY
(BIRDSCREEN FRONT SUPPORT)
Page 38