Specifications

Step 4:
After the four corners are assembled; the curb should be checked to be sure it is in "square". Do this by measuring
diagonally from each opposite corner. The two measurements should be the same for each direction as shown in Figure 5.
Step 3:
Corner Assembly: Align each curb side as shown in Figure 3. Using a hammer, drive the curb "hinge" pin down until the
top of the pin is below the top of the curb as shown in Figure 4.
Figure 3
Figure 4
HINGE
IN STAL LA TION IN STRUC TIONS
MODEL# (-)XKG SE RIES
ROOF CURBS
Figure 5
82
13
16
+
-
1
8
82
13
16
+
-
1
8
HINGE PIN
TAPERED END
CURB SIDE
Page 63