Specifications

Step 4:
After the four corners and middle hinges are assembled; the curb should be checked to be sure it is in "square". Do this by
measuring diagonally from each opposite corner. The two measurements should be the same for each direction as shown
in Figure 5. Then take the splice bracket (G) and secure to outside of the middle hinges.
Step 3:
Corner Assembly: Align each curb side as shown in Figure 3. Using a hammer, drive the curb "hinge" pin down until the
top of the pin is below the top of the curb as shown in Figure 4.
Figure 3
Figure 4
IN STAL LA TION IN STRUC TIONS
MODEL# (-)XKG SE RIES
ROOF CURBS
HINGE
HINGE PIN
TAPERED END
CURB SIDE
Figure 5
150
11
16
+
-
1
8
150
11
16
+
-
1
8
Page 71