Unit installation

Page 41 © 2009 Daikin 800-432-1342 www.DaikinApplied.com
IM 1024 - Cabinet Rear Extension Kit
The field-installed cabinet rear extension option may be
utilized to place the fan coil farther out from the wall than the
standard unit allows.
Note: This option is not designed to be an air duct or outside
air plenum.
Figure 1: Kit Components
Installation Instructions
1 Locate all components and remove from carton. See
Figure 1. Kit includes:
• Package of 23 screws - #8 x 0.375
• Left and Right Chassis Support Panels
• Center Chassis Support Panel
• Top Cabinet Panel
• Left and Right Cabinet Side Panels
• 2 Subbase Extensions
2 Attach Center Chassis Support Panel to Right and Left
Chassis Support Panels using 4 screws. See Figure 2.
Figure 2: Chassis & Subbase Assembly
Installation and Maintenance Manual IM 1024
Cabinet Rear Extension Kit for ThinLine™
3G Vertical Fan Coils and Unit Heaters
Group: Applied Air Systems
Part Number: 910102148
Date: August 2009
NOTICE
Installation and maintenance are to be performed only by
qualified personnel who are familiar with and in compliance
with state, local and national codes and regulations, and
experienced with this type of equipment.
Right Cabinet Side Panel
Left Cabinet Side Panel
Top Cabinet Panel
Right Chassis
Support Panel
Left Chassis
Support Panel
Subbase
Extension
Subbase
Extension
Center Chassis
Support Panel
#8 x 0.375
Screws (23)
DANGER
Electrical shock will cause severe injury or death. Disconnect
all electrical power before servicing unit.
WARNING
Wear protective gloves to avoid possible cuts and abrasions
from exposed edges. Avoid contact with sharp edges.
Slide Subbase Extensions onto
Chassis Support Panels and
fasten with screws
Fasten Center
Chassis Support
Panel to Left and
Right Panels with
4 screws