Installation Instructions

43
11-OPERATION
Technical Dept. - All rights reserved - Reproduction is prohibited
Load feed screw function
This function, which can only be turned on when the stove is o, is designed to load pellets into the loading system (feed screw). It should
be used whenever the pellet tank is empty (see alarm A02) to avoid a failed ignition (alarm A01) due precisely to the fact that there are
no more pellets in the tank.
Proceed as follows to activate the function:
• Set the rst selector to OFF
• Set the second selector to MED
• Make sure the word OFF appears on the display, as this function can only be activated when the stove is completely cold (o) and
the selector is set to OFF
• Press TEST 3 times within 2 seconds
• The display will show “OnPlt” in two subsequent intervals
• When the pellets start falling into the brazier, press TEST again to stop the LOAD FEED SCREW function or wait for the function to
stop on its own
• Turn the stove on.