Installation Instructions

15-CLEANING

Only by properly servicing and cleaning the product is it possible to ensure its safety and correct operation.

ATTENTION!

All the cleaning operations of all parts must be performed with the product completely cold and the plug

disconnected.

Disconnect the product from the 230V power supply before performing any maintenance operation.

The product requires little maintenance if used with certied good quality pellets.

DAILY OR WEEKLY CLEANING PERFORMED BY THE USER

Brazier cleaning

Before ignition, always clean the “T” brazier and remove any ash or incrustation from it that might obstruct the air ow holes, paying

attention to hot ash. In the case of ignition failure, or if fuel in the tank runs out, unburned pellets may accumulate in the brazier. Always

empty the residue in the brazier before each start-up. You may only use a vacuum cleaner to remove ash when it is completely

cold. In this case, use a suitable vacuum cleaner to remove small sized particles.

REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE SAFE IGNITION AND OPTIMAL

OPERATION OF YOUR PELLET PRODUCT. IN CASE OF FAILED IGNITION AND AFTER ANY OTHER LOCK STATE OF THE

PRODUCT, IT IS ESSENTIAL TO EMPTY THE BRAZIER BEFORE EVERY RESTART

For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate

on the bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating

conditions of the component.