Installation Instructions

A
B
Q
P
t
s
Q
52
15-CLEANING
PERIODIC CLEANING PERFORMED BY A QUALIFIED TECHNICIAN
CLEANING THE UPPER COMPARTMENT
Half-way through the winter season, but especially at the end, the compartment through which the exhaust smoke passes will need to
be cleaned.
This cleaning process is mandatory in order to facilitate the general removal of all combustion residues, before it becomes very dicult to
remove it due to the humidity compacting it over time.
CAUTION!
Cleaning is mandatory at the end of the season by an authorised and skilled technician, so that even the seals can
be replaced.
Clean the upper exchanger when the stove is cold. Remove ash pan “B”, brazier “A”, back panel “Q” and rear closure cap “P”. Then use a sti
rod or a bottle brush to scrape the walls of the replace (see arrow) to make the ash fall into the lower compartment. Then clean the lower
compartment (see following page).
To remove back panel “Q”, loosen screw “t” that blocks bracket “s” into place. Lift and slightly tilt back panel “Q” to remove it. To remove cap
“P”, lift it slightly so that it comes out of the interlocking systems and remove it.