Installation Instructions

5-INSTALLATION AND ASSEMBLY

POSITIONING

Before placing the product, assess optimal positioning condition.

The product can be installed in an already existing traditional replace or as new installation.

Furthermore, to raise the product, an iron support may be purchased separately (see special accessory price list - optional) or a platform

may be constructed on site as long as stability and safety of the Vivo 90 insert is assured.

The optional support raises the product by min. 50 cm to 65 cm maximum. This product may also be installed close to the oor without

using the optional pad. However, MCZ recommends complying with the safety measurements.

In any case, during installation the following factors should be taken into consideration to decide the height at which the insert is to be

placed:

• the dimensions of any cladding

• annual cleaning (see special section) since the inspection caps are underneath the product, therefore if it is placed too close to the

oor (see minimum measurements set out in this manual) the product will have to be completely extracted from its housing.

INSTALLATION ON AN EXISTING FIREPLACE

Evaluate the following elements:

The product’s support plane must have the following features:

• withstand the weight of the product and any accessories

• it should be strong enough to allow anchoring with dowels for securing

• perfectly level

• the shoulders as perpendicular as possible to the plane

the housing compartment must be suciently wide to house the product.

After ascertaining the required conditions for correct installation, proceed with assembling the product:

• fasten the base of the the product to the support

• perform the various connections to the ue complying with all regulations in force.

Any space between the walls of the cladding and the product may be closed with a compensation frame which must be easily detachable

in case of insert maintenance.

It is obligatory to fasten the product to the support, as it might tip over during product extraction.

It is required to ensure all connections (hydraulic and electric) allow for the product to be extracted.

NEW INSTALLATION