User guide

ATMOSPHERE
APS
& MAX
APS
Series
User Guide120815, Rev: A/c 9 / 15
 After the first purging cycle is completed (approx. time 30 to 60 sec.) the generator is
ready to operate.
 Press the Fog switch to produce Haze or Fog.
The CO
2
or N
2
gases are used as a propellant when generating Fog / Haze.
Output pressure can be adjusted by mean of the CO
2
or N
2
gas regulator. The ideal
range for MAX
APS
Series is 10 to 40 psi. and the H.O. / TOURING
APS
Version is 10 to 60
psi., for the ATMOSPHERE
APS
Series it is 5 to 20 psi. and the H.O. / TOURING
APS
Version
is 5 to 30 psi.
 Press again the Fog switch to stop to produce Haze or Fog.
The APS
TM
cycle is then automatically initiated to clear the heating module(s).
SHUT DOWN PROCEDURE
A Fog Generator must never be shut down while making Fog.
To power OFF a Generator, the following sequence must be observed:
 Always turn OFF the fog emission,
 Wait a minimum of 1 minute for the purge cycle to complete. If possible avoid
purging at very low pressure which reduces the efficiency of the Automatic Purging
System
TM
. The recommended minimum final purging pressure is 10 psi.
 Power OFF the Fog Generator (by switching off the “MAIN POWER SWITCH” or by
removing the MAIN POWER.