Specifications

MDS 05-3438A01, Rev. E MDS 4790/9790 Series I/O Guide 11
Invisible place holder
Figure 6. Typical Shipment Contents
4.2 Mounting the Radio
The radio should be located in a relatively clean, dust-free environment
that allows easy access to the rear panel connectors as well as the front
panel controls and indicators. Air must be able to pass freely over the
heatsink on the rear panel.
Figure 7 shows the mounting dimensions of the radio. Most commonly,
it is installed in a 2U/3.5 inch (88.90 mm) rack-mount configuration, but
it can also be installed in a simple tabletop arrangement if desired.
Rack Mounting
To rack-mount the radio, use the supplied mounting brackets
(MDS P/N 82-3184A01) to secure the chassis to the rack cabinet. The
brackets can be attached at any of four points on the sides of the enclo-
sure—front, back, middle facing front, and middle facing back (see
Figure 7). This flexibility ensures compatibility with most rack
mounting arrangements.
Tabletop Mounting
The radio can be placed on any sturdy shelf or tabletop that will support
the weight of the unit. Adhesive-backed rubber feet are provided with
the radio for use in tabletop installations. These should be placed under-
neath the chassis near each corner to prevent scratching of the mounting
surface.
PC DIAGNOSTICS & CONTROL
CD-ROM (OPTIONAL)
RACK-MOUNT BRACKETS (2)*
A
B
ES
C
AP
E
EN
TER
INSTALLATION
& OPERATION GUIDE
ADHESIVE FEET (4)*
(For tabletop mounting)
POWER CORD
(AC cord shown)
* These items may already be installed
on the radio chassis.