User manual

button through the hole. A double beep will indicate that

the thermostat is in “adhoc" mode. After activating the

“adhoc” mode, to see if the thermostat communicates,

press the "Update" button, you will read "Connected" if

yes or "device not found" if the sensor is not communi-

cating.

• The "Network" button allows you to set the parameters

of your network so that the thermostat can connect to

the same. The "Network Name" and “Password" fields

are case sensitive. In order to allow the thermostat to

connect to your network, set the required parameters

and press the "Send" button.

• The "Find device" button allows you to search ther-

mostats on the network and store the IP address in the

list of sensors (see next chapter). At the end of scanning,

that can last about 3-4 minutes, a message will appear

on the screen with the number of found sensors.

Sensors

This tab allows you to manage the list of your ther-

mostats.

Iphone

• The "Update" button allows you to update the list of

thermostats connected to your network. Using this func-

tion, a scan of the thermostats is performed and then