Operation Manual

GB
VISTUS AD | ENGLISH
14
INTRODUCTION
Thank you for choosing the VISTUS Video intercom system.
You have purchased a high quality system.
The assembly should be carried out by a specialist.
Care Information
Wipe the plastic casing with a slightly damp cloth. Do not use aggressive
cleaning materials.
Legend
Outdoor station
A.2= Loudspeaker
A.3= Nameplates /Bell button
A.4= Microphone
A.5= Casing screws
A.6= Brightness sensor
Indoor station
B. 3= Mute button
B. 4= Key button
B. 5= Microphone
B. 6= Talk button
B. 7= Internal button
B.11= Melody
B.12= Volume +
B.13= Volume -
B.14= Casing back
B.15= Snap fastener
C.1 = PCB screws
Scope of delivery VISTUS AD-4010:
1x Outdoor station with one bell button
1x Indoor station
1x Power supply ST-1000
1x Assembly materials
Scope of delivery VISTUS AD-4020:
1x Outdoor station with two bell buttons
2x Indoor station
1x Power supply ST-1000
1x Assembly materials
Scope of delivery VISTUS AD-4030:
1x Outdoor station with three bell buttons
3x Indoor station
1x Power supply ST-1000
1x Assembly materials
Scope of delivery VISTUS AD-400:
1x Indoor station
1x Assembly materials
PREPARING FOR INSTALLATION
The following lines are required:
Single-family house: 3 lines from the outdoor unit to the indoor unit
and 2 lines from the outdoor unit to the door opener.
Two- and three-family house: Here 3 lines are required per bell
button from the outdoor unit into each residential unit as well
as 2 lines from the outdoor unit to the door opener.
NOTE: A wiring plan can be found in the affix.
Up to four indoor units can be connected in parallel per residential unit.
The connection can be laid as
1. Serial connections (from indoor station to indoor station) or as
2. Radial connections (parallel) from one central point
(distribution box).
The wiring plan in the affix is base on a radial wiring
system as this is preferable.
The lines should be laid in such a way that each is fed out of the wall
directly behind the corresponding outdoor/indoor unit.
ASSEMBLY OF THE OUTDOOR STATION
The door intercom point is designed for surface mounting.
Preparation
When removing the front cover ensure that the nameplate does not fall
out and become damaged.
Also take care of the cable in the loudspeaker, which is attached in the
front part of the casing.
VISTUS AD-400_I-Manual_210x240_Fin8-1.indd 14 13.06.13 15:30