FIVE-CHANNEL REMOTE THERMO-HYGROMETER For Professional Weather Station TE923W-M USER MANUAL (TS34C-M)
TABLE OF CONTENTS INTRODUCTION STANDARD PACKAGE CONTENTS INSTALLATION BEFORE YOU BEGIN FEATURES TROUBLESHOOTING PRECAUTIONS SPECIFICATIONS FCC STATEMENT DECLARATION OF CONFORMITY BATTERY SAFETY INSTRUCTIONS STANDARD WARRANTY INFORMATION 2 3 3 3 4 5 7 7 8 8 9 10 11
Introduction Thank you for selecting a Meade Instruments 5-channel thermo-hygro sensor! Meade Instruments is the world’s leading designer and manufacturer of telescopes for professional and amateur astronomers – famous for its innovative, high performance telescopes at affordable prices. Meade Instruments now brings that same passion innovation and high performance to its own line of precision, feature rich weather stations.
Note: It is critical to power up and test communication between the remote sensor and the main unit BEFORE permanently mounting them outside. Before you begin • We recommend using alkaline batteries for the remote thermo-hygrometer when temperatures are above 32ºF (0ºC) and lithium batteries when temperatures are below 32ºF (0ºC). • Avoid using rechargeable batteries. (Rechargeable batteries cannot maintain correct power requirements).
Features • LCD display of measured temperature and humidity • Five (5) transmission channels selection • Case can be wall mounted using built-in hanger E 1 A C D B WIRELESS THERMO HYGRO A. LED INDICATOR • Flashes once when the remote sensor transmits a reading to the main unit. • Flashes twice when battery power is low. B. BATTERY COMPARTMENT Holds two AA-size batteries C. RESET Resets all readings D. CHANNEL SWITCH Selects the desired channel from 1 to 5 E.
Battery installation • Remove the screws from the battery compartment with a small Phillips screwdriver. • Set the channel 1 through 5. The switch is located in the battery compartment. Channel 1 is typically selected if only one remote thermo-hygrometer is being used. • Install 2 "AA" size alkaline batteries (not included) matching the polarities shown in the battery compartment. • Replace the battery compartment door and secure the screws. • Secure the remote thermo-hygrometer in the desired location.
Troubleshooting Q: "The remote sensor display shows dashes "---"" A: Press the RESET opening with a paper clip or similar tool. If this does not work, check the batteries and replace them. Q: "Main unit display in temperature and humidity portion shows dashes "---"" A: The display will show "- - -" when the wireless connection with the remote thermo-hygrometer is lost for 15 minutes Check or replace the batteries in remote sensor.
Specifications Radio Frequency: 433 MHz RF Reception range: 328 feet (100 m) Temperature Range: -40ºF to 122ºF (-40ºC to 50ºC) Resolution: 0.2ºF (0.1ºC) Accuracy: 2ºF (1ºC) Transmitting Interval: around 47 seconds Humidity Operating Range: 0% to 99% Resolution: 1% Accuracy: 5% Sampling Interval: 10 seconds Transmitting Interval: around 47 seconds Power: 2 x UM-3 or AA 1.5V battery Battery life (alkaline): over 12 months Weight (without batteries): 2.29oz (65g) Dimensions: 2.
There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to improve or correct turning the interference by one or more of the following measures: • Reorient or relocate the receiving antenna • Increase the separation between the equipment and receiver.
BATTERY SAFETY INSTRUCTIONS • Always purchase the correct size (2 x 1.5V AA, 15A/15AC ANSI, LR6 IEC), (2 x ANSI/NEDA-5004LC, IEC-CR2032) and grade of battery most suitable for the intended use. • Replace all batteries of a set at the same time. • Clean the battery contacts and also those of the device prior to battery installation. • Ensure the batteries are installed correctly with regard to polarity (+ and -).
STANDARD WARRANTY INFORMATION This product is warranted by Meade Instruments Corp. (MIC) to be free of defects in materials and workmanship for a period of ONE YEAR from date of original retail purchase in the U.S.A. MIC will repair or replace the product, or part thereof, found upon inspection by MIC to be defective, provided the defective part or product is returned to MIC, freight prepaid, with proof of purchase. This warranty applies to the original purchaser only and is non-transferable.
Meade Instruments Corp. 27 Hubble Irvine, CA 92618 U.S.A. © 2010 Meade Instruments Corporation. All Rights Reserved. All user manual contents and information are subject to change.