Datasheet

SPECIFICATION
MODEL APC-35-350
APC-35-700
DC VOLTAGE RANGE
RATED CURRENT
RATED POWER
OUTPUT
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
VOLTAGE RANGE Note.4
FREQUENCY RANGE
EFFICIENCY(Typ.)
AC CURRENT
INPUT
INRUSH CURRENT( )Typ.
LEAKAGE CURRENT
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVER VOLTAGE
28~100V
15~50V
350mA
700mA
35W
35W
350mVp-p
350mVp-p
±5.0%
±1.0%
±3.0%
1500ms, 40ms / 230VAC 1500ms, 40ms / 115VAC at full load
47 ~ 63Hz
84%
84%
0.5A/230VAC;0.75A/115VAC
0.25mA / 240VAC
20 ~ 90% RH non-condensing
-40 ~ +80℃, 10 ~ 95% RH
±0.2%/℃ (0 ~ 50℃)
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristic for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6.The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
35W Single Output Switching Power Supply
‧Constant current mode power supply
‧Universal AC input / Full range
‧Withstand 300VAC Surge input for 5 seconds
‧Protections:Short circuit / Over voltage
‧Fully isolated plastic case
‧Small and compact size
‧Cooling by free air convection
‧IP30 design
‧100% full load burn-in test
‧Suitable for LED lighting and moving sign applications
‧Low cost / High reliability
‧2 years warranty
RIPPLE & NOISE (max.) Note.2
VOLTAGE TOLERANCE Note.3
ENVIRONMENT
SAFETY &
EMC
(Note 5)
PROTECTION
File Name: APC-35-SPEC 2013-06-28
SAFETY STANDARDS
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3KVAC
HOLD UP TIME (Typ.) 20ms/230VAC 12ms/115VAC at full load
110 ~ 130V
55 ~ 65V
Protection type : Shut down o/p voltage, re-power on to recover
84*57*29.5(L*W*H)
COLD START 45A(twidth=490 s measured at 50% Ipeak) at 230VACμ
518.9K hrs min. MIL-HDBK-217F (25℃)
■ Features :
I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
90 ~ 264VAC 127 ~ 370VDC
APC-35 series
(only for APC-35-1050)
( only for APC-35-700)
UL8750 (only for APC-35-700&1050), CSA-C22.2 No. 250.0-13 (only for APC-35-1050) approved; design refer to EN60950-1
CURRENT ACCURACY
±8.0%
EMC IMMUNITY
Compliance to EN55022,EN61000-3-2 Class A,EN61000-3-3
Compliance to EN55024,EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV), criteria A
EMC EMISSION
APC-35-500
25~70V
500mA
35W
350mVp-p
84%
77 ~ 91V
APC-35-1050
11~33V
1050mA
34.7W
350mVp-p
84%
36 ~ 43V
-30 ~ 70℃(Refer to "Derating Curve")
0.18Kg; 72pcs/14Kg/0.92CUFT
LPS (except for APC-35-350,APC-35-500)