Data Sheet

SPECIFICATION
MODEL
OUTPUT
VOLTAGE RANGE
Note.5
FREQUENCY RANGE
POWER FACTOR
EFFICIENCY (Typ.)
AC CURRENT
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
EMC IMMUNITY
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSION
OTHERS
NOTE
PACKING
OVER TEMPERATURE
OVER VOLTAGE
500ms, 100ms/230VAC, 500ms, 100ms/115VAC
10ms/ 230VAC 10ms/ 115VAC
47 ~ 63Hz
3A / 115VAC 1.6A / 230VAC 1.3A/277VAC
<0.75mA / 277VAC
Compliance to
EN55015
,EN61000-3-2 Class C (@load 50%) ; EN61000-3-3;
20 ~ 95% RH non-condensing
-40 ~ + , 10 ~ 95% RH80
±℃ 0.03%/ (0 ~ 60 )
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
ENVIRONMENT
EMC EMISSION
SAFETY &
EMC
PROTECTION
Shut down output voltage, re-power on to recover
Shut down output voltage, re-power on to recover
SHORT CIRCUIT
I/P-O/P:3.75KVAC I/P-FG:2.0KVAC O/P-FG:1.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
TOTAL HARMONIC DISTORTION
DC VOLTAGE
RATED
CURRENT
RATED POWER
VOLTAGE ADJ. RANGE
CURRENT ADJ. RANGE
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
Note.6
HOLD UP TIME (Typ.)
RIPPLE & NOISE (max.) Note.3
VOLTAGE TOLERANCE
Note.4
CONSTANT CURRENT REGION Note.2
OVER CURRENT
COLD START 45A(twidth= s measured at 50% Ipeak) at 230VAC1200μ;Per NEMA 410
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
2 units (circuit breaker of type B) / 4 units (circuit breaker of type C) at 230VAC
MAX. CASE TEMP.
Tcase=+85
Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level ( )surge immunity Line-Earth 6KV, Line-Line 4KV
(Please refer to "STATIC CHARACTERISTIC" section)
100 ~ 305VAC 142 ~ 431VDC
1. All parameters NOT specially mentioned are measured at 230VAC input, rated and 25 of ambient temperature.current
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
4. Tolerance : includes set up tolerance, line regulation and load regulation.
5. De rating may be needed under low input voltages. Please .- refer to STATIC CHARACTERISTIC sections for details
6. Length of set up time is measured at first cold start. Turning ON/OFF the driver may lead to increase of the set up time.
7. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
8 . This series meets the typical life expectancy >50,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is 70 or less.
9. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com
10.The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude higher than 2000m(6500ft).℃℃
11. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED driver can only be used behind a switch without permanently connected to
the mains.
12. For any application note and IP water proof function installation caution, please refer our user manual before using.
https://www.meanwell.com/Upload/PDF/LED_EN.pdf
95 ~ 108%
Constant current limiting, recovers automatically after fault condition is removed
Constant current limiting, recovers automatically after fault condition is removed
PF 0.95/115VAC, PF 0.93/230VAC, PF 0.90/277VAC@full load≧≧
THD< 10%(@load 50%/115VC,230VAC; @load 75%/277VAC)≧≧
Tcase=-40 ~ +85 (Please refer to OUTPUT LOAD vs TEMPERATURE” section)
ELG-300-12A
12V
22A
150mVp-p
10~ 12V
264W
11.2 ~12.8V
11 ~ 22A
±3.0%
±0.5%
±2.0%
91%
13.5 ~ 17V
609K hrs min. Telcordia SR-332 (Bellcore) ; 191Khrs min. MIL-HDBK-217F (25 )
246 77**39.5mm (L*W*H)
1.45 Kg; 9pcs /13.5Kg / 0.76CUFT
224.4W
200VAC ~ 305VAC
100VAC ~ 180VAC
File Name:ELG-300-SPEC 2019-04-22
SAFETY STANDARDS
UL8750 ENEC EN61347-1, EN61347-2-13 independent, EN62384(type”HL”)(Except for 12V), CSA C22.2 No. 250.13-12; ;
EAC TP TC 004; GB19510.1 GB19510.14, ; IP67 approved
200VAC ~ 305VAC
100VAC ~ 180VAC
18.7A
300W Constant Voltage + Constant Current LED Driver
ELG-300
ELG-300-24A
24V
12.5A
240mVp-p
14.4~ 24V
300W
22.4 ~25.6V
6.25 ~ 12.5A
±2.0%
±0.5%
±1.0%
255W
10.63A
94%
27 ~ 34V