User manual

GC330 Instruction Manual
1
WARNING :
Please make sure the polarity of the battery is connected correctly!
:
1.Make sure the charger is shut off and cho osing suitable wire s to connect the charger and batteries based on the rating of charging
current. The polarity must be correct: charger output (+) sho uld be connected to the (+) term inal of batteries and charger output (-)
should be conne cted to the ( -) terminal.
In no times should the (+) and (-) be short together or the charger and batteries will be damaged.
2.Connect the AC input and check whether the op eration of LE D is correct.
(red : cha rging ; green : battery is full)
Assembly Procedure
1.The charg er sho uld be assembled in the place with good ventilation and low moisture.
Exposure to the rain or snow is strictly prohibite d.
2.Wires connecting between the charger and batteries should be as short as possible since the high voltage drop on the wires will
increase the time required to fully charge the batteries.
3.Make sure the charging voltage and charging current are suitable for the batteries you are using.
4.If the batt eries need to connect in series for cha rging, old ba tteries are not suggested to be used with new ones or the lifetime of
batteries may reduce because of the unbalance charg ing voltage distribution on new and old batteries.
5.Please turn off the cha rger before connecting or disconnecting the wires.
6.The charg er has a 2-year worldwide warranty, however, dam ages from misusing the charge r will not be included in the coverage of
warranty.
Note s On Operation:
PIN NO.
1,2
3,4
Standard male plug(power supply side): AMP 1-480702-0 equivalent
Female plug(customer side, not provide with the power supply): AMP 1-480703-0 equivalent
OUTPUT
+V
-V
POWER LED
UL2464 16AWGx4C 1000 50mm±
1
2
3
4