Datasheet
WITHSTANDVOLTAGE
ISOLATIONRESISTANCE
I/P-O/P:3.75KVACI/P-FG:2KVACO/P-FG:0.5KVAC
I/P-O/P,I/P-FG,O/P-FG:100MOhms/500VDC/25 /70%RH
¢J
HLG-150H-12
A
SPECIFICATION
MODEL
DCVOLTAGE
RATEDCURRENT
RATEDPOWER
OUTPUT
VOLTAGE ADJ.RANGE Note.5
CURRENT ADJ.RANGE
LINEREGULATION
LOADREGULATION
SETUP,RISETIME Note.7
HOLDUP TIME (Typ.)
VOLTAGERANGE Note.4
FREQUENCY RANGE
POWERFACTOR (Typ.)
EFFICIENCY (Typ.)
ACCURRENT (Typ.)
INPUT
INRUSHCURRENT( .)Typ
LEAKAGECURRENT
SAFETY STANDARDS Note.6
WORKINGTEMP.
WORKINGHUMIDITY
STORAGETEMP.,HUMIDITY
TEMP.COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVERCURRENT
OVERVOLTAGE
OVERTEMPERATURE
Canbeadjusted byinternalpotentiometer A typeonly
2500ms,80ms /115VAC;Btype2500ms,200msat95%load230VAC/115VACatfullload230VAC
16ms atfullload230VAC/115VAC
90~305VAC127~431VDC
47~63Hz
PF>0.98/115VAC,PF>0.95/230VAC,PF>0.92/277VACatfullload(Pleasereferto"PowerFactorCharacteristic"curve)
1.7A /115VAC0.75A /230VAC0.7A /277VAC
<0.75mA /277VAC
95~108%
Protectiontype:Constantcurrentlimiting,recoversautomaticallyafterfaultconditionisremoved
Complianceto EN55015,EN55022(CISPR22)ClassB,EN61000-3-2ClassC( 60%load);EN61000-3-3
¡Ù
CompliancetoEN61000-4-2,3,4,5,6,8,11,EN61547,EN55024,lightindustrylevel(surge4KV),criteria A
-40~+70 (Referto"DeratingCurve")
¢J
20~95%RH non-condensing
-40~+80 ,10~95%RH
¢J
¡Ó ¢J ¢J
0.03%/ (0~50 )
10~500Hz,5G12min./1cycle,periodfor72min.eachalongX, Y,Zaxes
192.2
¢J
Khrsmin.MIL-HDBK-217F(25 )
228*68*38.8mm
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltages. Please check the static characteristics for more details.
5. A type only.
6. Safety and EMC design refer to EN60598-1, subject 8750(UL), CNS15233, GB7000.1, FCC part18.
7. Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of the set up time.
8. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
9. Refer to warranty statement.
¢J
1.15Kg;12pcs/14.8Kg/0.8CUFT
150WSingleOutputSwitchingPowerSupply
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
Universal AC input / Full range (up to 305VAC)
Built-in active PFC function
Protections: Short circuit / Over current / Over voltage / Over temperature
Cooling by free air convection
OCP point adjustable through output cable or internal potentiometer
IP67 / IP65 design for indoor or outdoor installations
Three in one dimming function (1~10Vdc or PWM signal or resistance)
Suitable for LED lighting and street lighting applications
Compliance to worldwide safety regulations for lighting
5 years warranty (Note.9)
Suitable for dry / damp / wet locations
High efficiency up to 94%
¡½
Features :
HLG-150H se ri es
RIPPLE&NOISE(max.) Note.2
VOLTAGETOLERANCE Note.3
ENVIRONMENT
SAFETY &
EMC
PROTECTION
100 10 (RTH2)
¢J¡Ó ¢J
Protectiontype: Shutdowno/pvoltage,recoversautomaticallyaftertemperaturegoesdown
14~17V 18~21V
23~27V
28~34V
34~38V
41~46V 54~63V
47~53V 59~65V
91.5%
92%
93%
93%
93.5%
93.5%
94%94% 94%
¡Ó
2.5%
¡Ó
2.0%
¡Ó
1.0%
¡Ó
1.0%
¡Ó
1.0%
¡Ó
1.0%
¡Ó
1.0%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
2.0%
¡Ó
1.5%
¡Ó
1.0%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
1.0%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
1.0%
¡Ó
0.5%
¡Ó
0.5%
HLG-150H-12
HLG-150H-15
HLG-150H-20
HLG-150H-24
HLG-150H-30
HLG-150H-36
HLG-150H-48
12V 15V 20V 24V 30V
36V
48V
150mVp-p 150mVp-p
13.5~17V
150mVp-p
17~22V
150mVp-p
22~27V
200mVp-p
27~33V
200mVp-p
33~40V
200mVp-p
43~53V10.8~13.5V
HLG-150H-54
54V
200mVp-p
49~58V
HLG-150H-42
42V
200mVp-p
38~46V
7.5~12.5A 6~10A 4.5~7.5A 3.8~6.3A 3~5A
2.5~4.2A
1.92~3.2A 1.68~2.8A
2.16~3.6A
12.5A 10A 7.5A 6.3A
5A
4.2A
3.2A
150W 150W 150W 151.2W 150W
151.2W
153.6W
2.8A
151.2W
3.6A
151.2W
F M M
110
SELV
IP65 IP67
A : IP65 rated. Output voltage and constant current level can be adjusted through internal potentiometer.
B : IP67 rated. Constant current level adjustable through output cable with 1~10Vdc or 10V PWM signal or resistance.
Blank : IP67 rated. Cable for I/O connection.
SHORTCIRCUIT
Constantcurrentlimiting,recoversautomaticallyafterfaultconditionisremoved
Protectiontype: Shutdowno/pvoltagewithauto-recoveryorre-powerontorecovery
D (option) : IP67 rated. Timer dimming function, contact MEAN WELL for details.
EMCIMMUNITY
EMCEMISSION
UL8750,CSA C22.2No.250.0-08,EN61347-1,EN61347-2-13independentIP65orIP67,J61347-1,J61347-2-13approved;
designrefertoUL60950-1, TUVEN60950-1
COLDSTART 65A(t =425smeasuredat50%I )at230VAC
width peak
£g