Datasheet

ManualsBrandsMEAN WELL ManualsLED DriversLED Driver 90W 350mA 257V IP67

SPECIFICATION

MODEL

RATED CURRENT

RATED POWER

OUTPUT

CURRENT ADJ. RANGE

SETUP, RISE TIME

HOLD UP TIME (Typ.)

VOLTAGE RANGE

Note.2

FREQUENCY RANGE

POWER FACTOR (Typ.)

EFFICIENCY (Typ.)

AC CURRENT (Typ.)

INPUT

INRUSH CURRENT (Typ.)

LEAKAGE CURRENT

SAFETY STANDARDS

Note.3

WORKING TEMP.

WORKING HUMIDITY

STORAGE TEMP., HUMIDITY

TEMP. COEFFICIENT

VIBRATION

MTBF

DIMENSIONOTHERS

NOTE

PACKING

OVER TEMPERATURE

OVER VOLTAGE

Can be adjusted by internal potentiometer A type only

16ms at full load 230VAC / 115VAC

500ms, 80ms at full load 230VAC /115VAC

90 ~ 305VAC 127VDC ~ 431VDC

47 ~ 63Hz

0.88A / 115VAC 0.45A / 230VAC 0.38A / 277VAC

<0.75mA / 277VAC

-40 ~ +70 (Refer to "Derating Curve")℃

10 ~ 95% RH non-condensing

-40 ~ +80 , 10 ~ 95% RH℃

±℃ ℃0.03%/ (0 ~ 50 )

10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes

309.7K hrs min. MIL-HDBK-217F (25 )℃

195.6*61.5*38.8 mm (L*W*H)

RIPPLE CURRENT

ENVIRONMENT

SAFETY &

EMC

PROTECTION

300 ~ 340V

Shut down o/p voltage, re-power on to recover

Protection type : Shut down o/p voltage with auto-recovery or re-power on to recovery

SHORT CIRCUIT

91.5%

PF>0.98/115VAC, PF>0.96/230VAC, PF>0.94/277VAC at full load (Please refer to "Power Factor Characteristic" curve)

HLG-80H-C350 HLG-80H-C700

±5%

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃

2. Derating may be needed under low input voltages. Please check the static characteristics for more details.

3. Safety and EMC design refer to EN60598-1, CNS15233, GB7000.1.

4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the

complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.

5. Refer to warranty statement.

6. Please refer to "DRIVING METHODS OF LED MODULE".

7. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used behind a switch without permanently

connected to the mains.

Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, heavy industry level (surge L,N-FG: 4KV), criteria A

UL8750, CSA C22.2 No. 250.0-08, EN61347-1, EN61347-2-13 independent, IP65 or IP67 approved

Hiccup mode, recovers automatically after fault condition is removed

210 ~ 350mA 420 ~ 700mA

350mA

89.95W

A type : 128V ~ 257V B type : 167V ~ 257V

0.84Kg; 16pcs/14.4Kg/0.54CUFT

I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:1.5KVAC

I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃

WITHSTAND VOLTAGE

ISOLATION RESISTANCE

91.5%

150 ~ 170V

700mA

90.3W

A type : 64V ~ 129V B type : 84V ~ 129V

■ Features :

A : IP65 rated. Constant current level can be adjusted through internal potentiometer.

B : IP67 rated. Constant current level adjustable through output cable with 1~10Vdc or 10V PWM signal or resistance.

(option) : IP67 rated. Timer dimming function, contact MEAN WELL for details.

Constant current design

Universal AC input / Full range (up to 305VAC)

Built-in active PFC function

High efficiency up to 91.5%

Protections: Short circuit / Over voltage / Over temperature

Cooling by free air convection

Output current adjustable through output cable or internal potentiometer

IP67 / IP65 design for indoor or outdoor installations

Three in one dimming function (1~10Vdc or 10V PWM signal or resistance)

Suitable for dry / damp / wet locations

5 years warranty (Note.5)

FMM

110

IP65 IP67

HLG-80H-C350

90W Single Output LED Power Supply

HLG-80H-C series

File Name:HLG-80H-C-SPEC 2015-05-11

EMC IMMUNITY

EMC EMISSION

CURRENT ACCURACY ±5.0%

Compliance to EN55015, EN61000-3-2 Class C ( 50% load) ; EN61000-3-3≧

CONSTANT CURRENT REGION

Note.6

RIPPLE & NOISE

1Vp-p 0.5Vp-p

±1%LINE REGULATION

±1%

THD< 20% when output loading 60% at 115VAC/230VAC input and output loading 75% at 277VAC input≧≧

TOTAL HARMONIC DISTORTION

MAX. No. of PSUs on 16A

CIRCUIT BREAKER

4 units (circuit breaker of type B) / 8 units (circuit breaker of type C) at 230VAC

COLD START 60A(t =410 s measured at 50% I ) at 230VACwidth peak

Summary of content (6 pages)

PAGE 1
HLG-80H-C 90W Single Output LED Power Supply series ■ Features : Constant current design Universal AC input / Full range (up to 305VAC) Built-in active PFC function High efficiency up to 91.
PAGE 2
HLG-80H-C 90W Single Output LED Power Supply Mechanical Specification Case No.997A series Unit:mm A Type:(HLG-80H-C_A) 195.6 171.8 12 9.6 300±20 T case 30.75 SJTW 16AWG×3C 61.5 300±20 32 46.5 AC/L(Brown) AC/N(Blue) FG (Green/Yellow) 85.9 Io ADJ. SJTW 16AWG×2C +V(Red) -V(Black) ψ4.2×4PL 38.8 ※ T case: Max. Case Temperature. ※ IP65 rated. Constant current level can be adjusted through internal potentiometer. (Can access by removing the rubber stopper on the case.
PAGE 3
HLG-80H-C 90W Single Output LED Power Supply series D Type:(HLG-80H-C_D) 195.6 171.8 12 9.6 300±20 85.9 +V(Red) -V(Black) SJTW 16AWG×2C 30.75 SJTW 16AWG×3C T case 61.5 32 46.5 300±20 AC/L(Brown) AC/N(Blue) FG (Green/Yellow) ψ4.2×4PL 38.8 ※ T case: Max. Case Temperature. ※ IP67 rated. Timer dimming function, contact MEAN WELL for details.
PAGE 4
HLG-80H-C 90W Single Output LED Power Supply series Power Factor Characteristic Constant Current Mode 1 0 .9 9 0 .9 8 0 .9 7 0 .9 6 PF 0 .9 5 277VAC 0 .9 4 230VAC 0 .9 3 115VAC 0 .9 2 0 .9 1 0 .9 0 .8 9 0 .8 8 50% 60% 70% 80% 90% 100% (90W) LOAD EFFICIENCY vs LOAD (HLG-80H-C700A Model) EFFICIENCY (%) HLG-80H-C series possess superior working efficiency that up to 92% can be reached in field applications.
PAGE 5
HLG-80H-C 90W Single Output LED Power Supply series DIMMING OPERATION (for B-type only) +V(Red) -V(Black) AC/L(Brown) AC/N(Blue) FG (Green/Yellow) HLG-80H-C DIM+(Blue) DIM-(White) ※ Built-in 3 in 1 dimming function, IP67 rated. Output constant current level can be adjusted through output cable by connecting a resistance or 1 ~ 10Vdc or 10V PWM signal between DIM+ and DIM-. ※ Please DO NOT connect "DIM-" to "-V".
PAGE 6
HLG-80H-C 90W Single Output LED Power Supply series WATERPROOF CONNECTION ◎ Waterproof connector Waterproof connector can be assembled on the output cable of HLG-80H-C to operate in dry/wet/damp or outdoor environment. AC source HLG-80H-C I/P Size O/P Pin Configuration (Female) M12 Order No. Suitable Current 4-PIN 5A/PIN M12-04 10A max. 5-PIN 5A/PIN M12-05 10A max. Size Pin Configuration (Female) M15 2-PIN 12A/PIN M15-02 12A max. Order No.