Datasheet

ManualsBrandsMEAN WELL ManualsPSU ComponentsAC/DC PSU module (+ enclosure) 324 W

Universal AC input / Full range

Built-in active PFC function, PF>0.95

High efficiency up to 89%

Protections: Short circuit / Overload / Over voltage / Over temperature

DC OK signal

emote ON-OFF control

Standby 5V@0.3A

No load power consumption<0.5W (Note.6)

5 years warranty

Withstand 300VAC surge input for 5 seconds

Built-in constant current limiting circuit

1U low profile 41mm

Built-in cooling fan ON-OFF control

Built-in

Built-in r

Built-in remote sense function

SPECIFICATION

HRPG-300-3.3 HRPG-300-5 HRPG-300-7.5 HRPG-300-12 HRPG-300-15 HRPG-300-24 HRPG-300-36 HRPG-300-48

MODEL

DCVOLTAGE

RATEDCURRENT

CURRENTRANGE

RATEDPOWER

RIPPLE&NOISE(max.) Note.2

OUTPUT VOLTAGE ADJ.RANGE

VOLTAGETOLERANCE Note.3

LINEREGULATION

LOADREGULATION

SETUP,RISETIME

HOLDUP TIME (Typ.)

VOLTAGERANGE Note.5

FREQUENCY RANGE

POWERFACTOR (Typ.)

EFFICIENCY (Typ.)

INPUT

ENVIRONMENT

INRUSHCURRENT (Typ.)

LEAKAGECURRENT

OVERTEMPERATURE

SAFETY STANDARDS

HARMONICCURRENT

EMICONDUCTION&RADIATION

SAFETY &

EMSIMMUNITY

EMC

(Note4)

WITHSTANDVOLTAGE

ISOLATIONRESISTANCE

WORKINGTEMP.

DCOKSIGNAL

REMOTECONTROL

WORKINGHUMIDITY

STORAGETEMP.,HUMIDITY

TEMP.COEFFICIENT

VIBRATION

MTBF

DIMENSIONOTHERS

NOTE

PACKING

OVERLOAD

OVERVOLTAGE

PROTECTION

ACCURRENT (Typ.)

3.3V 5V 7.5V 12V 15V 24V 36V 48V

60A

60A 40A 27A 22A 14A 9A 7A

0~60A 0~60A 0~40A 0~27A 0~22A 0~14A 0~9A 0~7A

198W 300W 300W 324W 330W 336W 324W 336W

80mVp-p 90mVp-p 100mVp-p 120mVp-p 150mVp-p 150mVp-p 250mVp-p 250mVp-p

2.8~3.8V 4.3~5.8V 6.8~9V 10.2~13.8V 13.5~18V 21.6~28.8V 28.8~39.6V 40.8~55.2V

2.5% 2.0% 2.0% 1.0% 1.0% 1.0% 1.0% 1.0%

0.5% 0.5% 0.5% 0.3% 0.3% 0.2% 0.2% 0.2%

1.0% 1.0% 1.0% 0.5% 0.5% 0.5% 0.5% 0.5%

1000ms,50ms/230VAC2500ms,50ms/115VACatfullload

16ms/230VAC16ms/115VACatfullload

85~264VAC120~370VDC

47~63Hz

PF>0.95/230VACPF>0.99/115VACatfullload

80% 82%

6~7V 9.4~10.9V 14.4~16.8V 18.8~21.8V 30~34.8V 41.4~48.6V 57.6~67.2V

86% 88% 88% 87% 88% 89%

5A/115VAC2.5A/230VAC

35A/115VAC70A/230VAC

<1.2mA /240VAC

105~135%ratedoutputpower

3.96~4.62V

Protectiontype: Constantcurrentlimiting,recoversautomaticallyafterfaultconditionisremoved

Protectiontype:Shutdowno/pvoltage,re-powerontorecover

Protectiontype:Shutdowno/pvoltage,recoversautomaticallyaftertemperaturegoesdown

100 5 for3.3V,5V,7.5V;95 5 forothers(TSW2: powerdiod

detectonheatsinkof e)

90 5 (TSW1:

detectonheatsinkofpowertransistor)

UL60950-1, TUVEN60950-1approved

CompliancetoEN55022(CISPR22)ClassB

Complianceto EN61000-3-2,-3

CompliancetoEN61000-4-2,3,4,5,6,8,11,ENV50204,EN55024,EN61000-6-2, heavyindustrylevel,criteria A

I/P-O/P:3KVACI/P-FG:1.5KVACO/P-FG:0.5KVAC

I/P-O/P,I/P-FG,O/P-FG:100MOhms/500VDC/25 /70%RH

-40~+70 (Refertooutputloadderatingcurve)

RC+/RC-:4~10Voropen=poweron;0~0.8Vorshort=poweroff

PSUturnson:3.3~5.6V;PSUturnsoff:0~1V

20~90%RHnon-condensing

-40~+85 ,10~95%RH

0.03%/ (0~50 )

10~500Hz,5G10min./1cycle,60min.eachalongX, Y,Zaxes

176Khrsmin.MIL-HDBK-217F(25 )

199*105*41mm(L*W*H)

FileName:HRPG-300-SPEC2010-11-29

Features :

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance : includes set up tolerance, line regulation and load regulation.

4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets

EMC directives.

5. Derating may be needed under low input voltages. Please check the derating curve for more details.

6. No load power consumption<0.5W when RC- & RC+ (CN100 pin4,6) 0 ~ 8V or short.

For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies.

(as available on http://www.meanwell.com)

HRPG-300 s er ie s

300WSingleOutputwithPFCFunction

FUNCTION

0.95Kg;15pcs/15.3Kg/0.69CUFT

5VSTANDBY

5VSB:5V@0.3A ;tolerance 5%,ripple:50mVp-p(max.)

FANCONTROL (Typ.)

Load35 15%orRTH2 50 Fanon

Summary of content (4 pages)

PAGE 1
HRPG-300 300W Single Output with PFC Function series Features : Universal AC input / Full range Built-in active PFC function, PF>0.95 High efficiency up to 89% Withstand 300VAC surge input for 5 seconds Protections: Short circuit / Overload / Over voltage / Over temperature Built-in constant current limiting circuit 1U low profile 41mm Built-in cooling fan ON-OFF control Built-in DC OK signal Built-in remote ON-OFF control Standby 5V@0.3A Built-in remote sense function No load power consumption<0.
PAGE 2
HRPG-300 300W Single Output with PFC Function Mechanical Specification Unit:mm 18 12.5 Case No.980A series 4-M4 L=6 12.25 168.5 199 12.25 168.5 120 42.5 1 4 6 7 LED CN100 SVR Terminal HRS DF11-**SC or equivalent HRS DF11-8DS or equivalent 167.5 12.25 167.5 12.25 17max. 12.5 18 41 Mating Housing 4-M4 L=6 fosc : 70KHz Block Diagram ACTIVE INRUSH CURRENT LIMITING EMI FILTER I/P Air flow direction 15 1 7 2 8 Connector Pin No.
PAGE 3
HRPG-300 300W Single Output with PFC Function series Function Description of CN100 Pin No. Function Description Auxiliary voltage output, 4.75~5.25V, reference to pin 2(AUXG). The maximum load current is 0.3A. This output has the built-in oring 1 AUX diodes and is not controlled by the "remote ON/OFF control". Auxiliary voltage output ground. The signal return is isolated from the output terminals (+V & -V). DC-OK signal is a TTL level signal, referenced to pin5(DC-OK GND). High when PSU turns on.
PAGE 4
HRPG-300 300W Single Output with PFC Function series 3.Remote Control The PSU can be turned ON/OFF by using the "Remote ON/OFF" function Between RC+(pin3) and RC-(pin5) Output Status SW ON (Short) OFF SW OFF (Open) ON CN100 1 2 3 4 5 6 7 CN100 1 AUX DC-OK GND 2 AUXG RC- RC+ +S 7 -S 8 1 7 2 8 SW Fig 3.