PB -300 / 360 Instruction Manual
PB-300,360 Instruction Manual ON/OFF SWITCH 230/115VAC SWITCH 230 INLET 3 POLE IEC320 C14 Battery Connection LED +V -V SVR1 CN5 Vadj RC VR DC (-) DC (+) WARNING : Please make sure the polarity of the battery is connected correctly! Battery Assembly Procedure : 1.Make sure the charger is shut off and choosing suitable wires to connect the charger and batteries based on the rating of charging current.
5.If the batteries need to connect in series for charging, old batteries are not suggested to be used with new ones or the lifetime of batteries may reduce because of the unbalance charging voltage distribution on new and old batteries. 6.Please turn off the charger before connecting or disconnecting the wires. 7.The charger has a 3-year worldwide warranty, however, damages from misusing the charger will not be included in the coverage of warranty.
2.Below the ambient temperature of 40 , PB-360 can provide the maximum charging current to the batteries. If the ambient temperature is higher than 40 , the output current of PB-360 will decrease automatically. Please refer to the derating curve shown as below: 100 90 80 LOAD (%) 70 60 40 30 -20 10 20 30 40 50 60 70 AMBIENT TEMPERATURE ( ) Selection Of Output Connection: Please choose wires with suitable diameter of its cross section based on the current rating.
WARNING : Explosive gases. prevent flames and sparks, Provide adequate ventilation during charging. Disconnect the supply before making or breaking the connections to the battery. Against recharging non-rechargeable batteries. CAUTION : (1)Temperature of the case will be high during the charging operation. (2)If the AC input terminal does not connect to F.G. or the ground, then the case should be grounded or the leakage current may harm the users while touching the case.