Datasheet

ManualsBrandsMEAN WELL ManualsBattery ChargersVRLA charger PB-Akkulader 28,8V 21A 24 V SLA, Lead-acid, Lead acid membrane

‧

2/3/8 stage charging (Note 4)

‧

Universal AC input / Full range

‧

Built-in active PFC function PF>0.95

‧

Protection: Reverse polarity / Short circuit / Over voltage / Over temperature

‧

Charger for lead-acid batteries

‧

3 color LED loading indicator

‧

Built-in remote ON-OFF control

‧

Built-in temperature compensation function

‧

(depends on charging current)Built-in fan speed control

‧

3 years warranty

■

Features :

SPECIFICATION

PB-600-12 PB-600-24 PB-600-48

MODEL

BOOST CHARGE VOLTAGE

FLOAT CHARGE VOLTAGE

OUTPUT CURRENT

BATTERY TYPE

RECOMMENDED BATTERY

CAPACITY(AMP HOURS)

(Note 3)

OUTPUT

VOLTAGE RANGE

FREQUENCY RANGE

EFFICIENCY (Typ.)

INPUT

ENVIRONMENT

INRUSH CURRENT (Typ.)

LEAKAGE CURRENT

OVER TEMPERATURE

SAFETY STANDARDS

SAFETY &

EMC

(Note 2)

WITHSTAND VOLTAGE

ISOLATION RESISTANCE

WORKING TEMP.

WORKING HUMIDITY

STORAGE TEMP., HUMIDITY

TEMP. COEFFICIENT

VIBRATION

OVER VOLTAGE

PROTECTION

AC CURRENT (Typ.)

14.4V 28.8V 57.6V

13.8V

40A

Open & Sealed Lead Acid

135 ~ 400AH

27.6V 55.2V

21A 10.5A

70 ~ 210AH 35 ~ 105AH

90 ~ 264VAC 127 ~ 370VDC

47 ~ 63Hz

86% 87% 89%

6.8A/115VAC 3.4A/230VAC

25A/115VAC 50A/230VAC

<3.5mA / 240VAC

16 ~ 18V 32 ~ 35V 64.5 ~ 69.5V

Protection type : Shut down o/p voltage, re-power on to recover

Protection type : Shut down o/p voltage, recovers automatically after temperature goes down

UL1012, TUV EN60335-1, EN60335-2-29 (except for 48V), EN60950-1(48V only) approved

Compliance to EN55022 class B (CISPR22), EN61000-3-2,-3

Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024; light industry level, criteria A

I/P-O/P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC

I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃

-20 ~ +60 (Refer to "Derating Curve")℃

20 ~ 90% RH non-condensing

-40 ~ +85 , 10 ~ 95% RH ℃

± ℃ ℃0.05%/ (0 ~ 50 )

10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes

MTBF

135.6K hrs min. MIL-HDBK-217F (25 )℃

230*158*67mm(L*W*H)

DIMENSIONOTHERS

NOTE

PACKING

2.2Kg; 6pcs/14.2Kg/1.76CUFT

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃

2. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets

EMC directives.

3. This is Mean Well's suggested range. Please consult your battery manufacturer for their suggestions about maximum charging current limitation.

4. Please choose the "3 stage" selection when the charger is used to charge the batteries and power the loads in the same time.

PB-600

series

600W Single Output Battery Charger

FUNCTION

REMOTE CONTROL

LEAKAGE CURRENT FROM BATTERY (Typ.)

FAST CHARGE

OUTPUT OK

CHARGER OK

TEMPERATURE SENSE

Open: Normal work Short: Stop Charging

1mA

2 / 3 / 8 stage selectable

Relay contact (RY13)

Relay contact (RY15)

By NTC

File Name:PB-600-SPEC 2014-09-15

POWER FACTOR (Typ.) 0.95/230VAC 0.98/115VAC at full load

EMC IMMUNITY

EMC EMISSION

Summary of content (5 pages)

PAGE 1
PB-600 600W Single Output Battery Charger series ■ Features : ‧2/3/8 stage charging (Note 4) ‧Universal AC input / Full range ‧Built-in active PFC function PF>0.
PAGE 2
PB-600 600W Single Output Battery Charger Mechanical Specification Case No.805C series Unit:mm 230 145 67 42.5 7 ON/OFF SWITCH INLET Air flow direction 48 24.1 Control Pin No. Assignment(CN100) : HRS DF11-10DP-2DS or equivalent Pin No. 1,2 3,4 5,6 7 Assignment RY13 NC RY15 GND RY13 : Battery bank OK RY15 : Charger OK Pin No.
PAGE 3
PB-600 600W Single Output Battery Charger series 8 Stage Pulse Soft S tart Constant Current Constant Voltage Analysis Recond Float Maintain stage 1 stage 2 stage 3 stage 4 stage 5 stage 6 stage 7 stage 8 Charge Voltage Charge Current Orange Color of LED Green Block Diagram PFC : 95KHz PWM fosc : 60KHz ACTIVE INRUSH CURRENT LIMITING EMI FILTER I/P RECTIFIER & PFC RECTIFIER & FILTER POWER SWITCHING +V PFC CONTROL PWM CONTROL AUX POWER CURRENT DETECTION REVERSE DETECTION MCU
PAGE 4
PB-600 600W Single Output Battery Charger Function Description of CN100 series The Function of LEDs Pin No. Function Description Relay contact rating(max.) : 30V/1A resistive. ; "Short" when the battery is full, 1,2 RY13 "Open" when the battery is still charging Color Status Red 5,6 RY15 Relay contact rating(max.) : 30V/1A resistive.
PAGE 5
PB-600 600W Single Output Battery Charger series 4.Output OK (RY13) CN100 1.Bank OK (RY13) Bank Between pin1 and pin2(RY13) Color of LED Battery Full ON (Short) Green Charging OFF (Open) Orange 1 Power RY13 RY13 NC Stage 8/3/2 2 NC RY15 RY15 GND RTH 10 9 + RC- RC+ 10 RY13 Battery 5.Temperature compensation Temperature sensor comes along with the charger can be connected to the unit to allow temperature compensation of the charging voltage.