Datasheet
AC/L(BROWN)
+V(RED)
-V(BLACK)
DIM-(WHITE)
DIM+(BLUE)
AC/N(BLUE)
+
-
LED Strip
+
-
File Name:PWM-90-SPEC 2014-10-21
90W PWM output LED power supply
PWM-90 series
Installation Manual
◎Connection
◎Cautions
Before commencing any installation or maintenance work, please disconnect the power supply from the utility. Ensure‧
that it cannot be re-connected inadvertently!
Keep proper ventilation around the unit and do not stack any object on it. Also a 10-15 cm clearance must be kept when ‧
the adjacent device is a heat source.
Mounting orientations other than standard orientation or operate under high ambient temperature may increase the ‧
internal component temperature and will require a de-rating in output current.
Current rating of an approved primary /secondary cable should be greater than or equal to that of the unit. Please refer ‧
to its specification.
For LED power supplies with waterproof connectors, verify that the linkage between the unit and the lighting fixture is ‧
tight so that water cannot intrude into the system.
For dimmable LED power supplies, make sure that your dimming controller is capable of driving these units.PWM series ‧
require 0.15mA each unit.
Tc max. is identified on the product label. Please make sure that temperature of Tc point will not exceed limit.‧
DO NOT connect "DIM+ to -V".‧
‧Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30
minutes.
‧The power supply is considered as a component that will be operated in combination with final equipment. Since EMC
performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC
Directive on the complete installation again.
‧For more information about installation, please refer to www.meanwell.com/webnet/search/installationsearch.html
for details.
0~10Vdc or 10V PWM
or resistance Dimmer