Datasheet

SPECIFICATION
RSP-1500-5
MODEL
DCVOLTAGE
RATEDCURRENT
CURRENTRANGE
RATEDPOWER
OUTPUT VOLTAGE ADJ.RANGE
LINEREGULATION
LOADREGULATION
SETUP,RISETIME
HOLDUP TIME (Typ.)
VOLTAGERANGE
FREQUENCY RANGE
EFFICIENCY (Typ.)
INPUT
INRUSHCURRENT (Typ.)
LEAKAGECURRENT
OVERTEMPERATURE
WORKINGTEMP.
CURRENTSHARING
OUTPUTVOLTAGETRIM
ALARMSIGNAL OUTPUT
REMOTEON/OFFCONTROL
AUXILIARY POWER(AUX)
WORKINGHUMIDITY
STORAGETEMP.,HUMIDITY
TEMP.COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVERLOAD Note.5
OVERVOLTAGE
ACCURRENT (Typ.)
5V
240A
0~240A
1200W
150mVp-p
4.5~5.5V
2.0%
0.5%
2.0%
1500ms,100msatfullload
10msatfullload 14msatfullload 16msatfullload
90~264VAC127~370VDC
47~63Hz
80%
17A/115VAC8A/230VAC
30A/115VAC60A/230VAC
<2.0mA /240VAC
105~135% ratedoutputpower
5.75~6.75V
Protectiontype:Constantcurrentlimitingunitwillshutdowno/pvoltageafter5sec.Re-powerontorecover
13.8~16.8V 17~20.5V 27.6~32.4V 31~36.5V 57.6~67.2V
Protectiontype:Shutdowno/pvoltage,re-powerontorecover
95 5 (TSW2)detectonheatsinkofpowertransistor
Protectiontype:Shutdowno/pvoltage,recoversautomaticallyaftertemperaturegoesdown
-20~+70 (Refertooutputloadderatingcurve)
PleaseseetheFunctionManual
PleaseseetheFunctionManual
PleaseseetheFunctionManual
PleaseseetheFunctionManual
12V@0.1A(OnlyforRemoteON/OFFcontrol)
20~90%RHnon-condensing
-40~+85 ,10~95%RH
0.05%/ (0~50 )
10~500Hz,2G10min./1cycle,60min.eachalongX, Y,Zaxes
62.6Khrsmin.MIL-HDBK-217F(25 )
278*127*83.5mm(L*W*H)
3.0Kg;4pcs/13Kg/1.19CUFT
87% 87% 90% 90% 91%
0.5% 0.5% 0.5% 0.5% 0.5%
0.5% 0.5% 0.5% 0.5% 0.5%
1.0% 1.0% 1.0% 1.0% 1.0%
150mVp-p
10~13.5V
150mVp-p
13.5~16.5V
150mVp-p
20~26.4V
150mVp-p
24~30V
200mVp-p
43~56V
12V
125A
0~125A
1500W
15V
100A
0~100A
1500W
24V
63A
0~63A
1512W
27V
56A
0~56A
1512W
48V
32A
0~32A
1536W
RSP-1500-12 RSP-1500-15 RSP-1500-24 RSP-1500-27 RSP-1500-48
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
5. Derating may be needed under low input voltages. Please check the derating curve for more details.
For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies.
(as available on http://www.meanwell.com)
FileName:RSP-1500-SPEC2010-10-18
POWERFACTOR (Typ.) 0.95/230VAC0.98/115VACatfullload
SAFETY STANDARDS
HARMONICCURRENT
EMSIMMUNITY
UL60950-1, TUVEN60950-1approved
CompliancetoEN55022(CISPR22)
Complianceto EN61000-3-2,-3
Complianceto EN61000-4-2,3,4,5,6,8,11;ENV50204,EN55024,lightindustrylevel,criteria A
1500WSingleOutputPowerSupply
RSP-1500 se ri es
RIPPLE&NOISE(max.) Note.2
VOLTAGETOLERANCE Note.3
EMICONDUCTION&RADIATION
WITHSTANDVOLTAGE
ISOLATIONRESISTANCE
I/P-O/P:3KVACI/P-FG:1.5KVACO/P-FG:0.5KVAC
I/P-O/P,I/P-FG,O/P-FG:100MOhms/500VDC /25 /70%RH
ENVIRONMENT
SAFETY &
FUNCTION
EMC
(Note4)
PROTECTION
Universal AC input/Full range
ZVS new technology
AC input active surge current limiting
High efficiency up to 91%
Built-in active PFC function,PF>0.95
Protections: Short circuit / Overload / Over voltage / Over temperature
Forced air cooling by built-in DC ball bearing fan
Output voltage can be trimmed between 70~100% of the rated output voltage
High power density 8.3W/inch
Current sharing up to 6000W(3+1)
Alarm signal output
Built-in 12V/0.1A auxiliary output for remote control
Built-in remote ON-OFF control
Built-in remote sense function
3 years warranty
3
Features :