Datasheet

SPECIFICATION
RSP-3000-12
MODEL
DCVOLTAGE
RATEDCURRENT
CURRENTRANGE
RATEDPOWER
OUTPUT VOLTAGE ADJ.RANGE
LINEREGULATION
LOADREGULATION
SETUP,RISETIME
HOLDUP TIME (Typ.)
VOLTAGERANGE
FREQUENCY RANGE
EFFICIENCY (Typ.)
INPUT
INRUSHCURRENT (Typ.)
LEAKAGECURRENT
OVERTEMPERATURE
WORKINGTEMP.
CURRENTSHARING
OUTPUTVOLTAGETRIM
ALARMSIGNAL OUTPUT
REMOTEON/OFFCONTROL
AUXILIARY POWER(AUX)
WORKINGHUMIDITY
STORAGETEMP.,HUMIDITY
TEMP.COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVERLOAD
OVERVOLTAGE
ACCURRENT (Typ.)
12V
200A
0~200A
2400W
150mVp-p
10.8~13.2V
1.0%
0.5%
0.5%
1000ms,80msatfullload
10msatfullload
180~264VAC254~370VDC
47~63Hz
86%
20A/180VAC16A/230VAC
60A/230VAC
<2.0mA /240VAC
100~112% ratedoutputpower
13.8~16.8V
Useradjustablecontinuousconstantcurrentlimitingorconstantcurrentlimitingwithdelayshutdownafter5seconds,re-powerontorecover
28.8~33.6V
4.8~28V
57.6~67.2V
9.6~56V
Protectiontype:Shutdowno/pvoltage,re-powerontorecover
Protectiontype:Shutdowno/pvoltage,recoversautomaticallyaftertemperaturegoesdown
-20~+70 (Refertooutputloadderatingcurve)
PleaseseetheFunctionManual
PleaseseetheFunctionManual
2.4~13.2V
PleaseseetheFunctionManual
12V@0.1A(OnlyforRemoteON/OFFcontrol)
20~90%RHnon-condensing
-40~+85 ,10~95%RH
0.05%/ (0~50 )
10~500Hz,2G10min./1cycle,60min.eachalongX, Y,Zaxes
104.5Khrsmin.MIL-HDBK-217F(25 )
278*177.8*63.5mm(L*W*H)
4Kg;4pcs/16Kg/1.89CUFT
90% 90.5%
0.5% 0.5%
0.5% 0.5%
1.0% 1.0%
150mVp-p
22~28V
200mVp-p
43~56V
24V
125A
0~125A
3000W
48V
62.5A
0~62.5A
3000W
RSP-3000-24 RSP-3000-48
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies.
(as available on http://www.meanwell.com)
FileName:RSP-3000-SPEC2010-10-18
POWERFACTOR (Typ.) 0.95/230VACatfullload
SAFETY STANDARDS
HARMONICCURRENT
EMSIMMUNITY
UL60950-1, TUVEN60950-1approved
CompliancetoEN55022(CISPR22)
Complianceto EN61000-3-2,-3
Complianceto EN61000-4-2,3,4,5,6,8,11;ENV50204,EN55024,lightindustrylevel,criteria A
3000WSingleOutputPowerSupply
RSP-3000 se ri es
RIPPLE&NOISE(max.) Note.2
VOLTAGETOLERANCE Note.3
EMICONDUCTION&RADIATION
WITHSTANDVOLTAGE
ISOLATIONRESISTANCE
I/P-O/P:3KVACI/P-FG:1.5KVACO/P-FG:0.5KVAC
I/P-O/P,I/P-FG,O/P-FG:100MOhms/500VDC /25 /70%RH
ENVIRONMENT
SAFETY &
FUNCTION
EMC
(Note4)
PROTECTION
AC input 180 ~ 264VAC
AC input active surge current limiting
High efficiency up to 90%
Built-in active PFC function,PF>0.95
Protections: Short circuit / Overload / Over voltage / Over temperature
/ Fan alarm
Forced air cooling by built-in DC with fan speed control function
Output voltage can be trimmed between 20~110% of the rated output voltage
High power density 15.6W/inch
Current sharing up to 3 units
Alarm signal output (relay contact and TTL signal)
Built-in 12V/0.1A auxiliary output for remote control
Built-in remote ON-OFF control
Built-in remote sense function
3 years warranty
3
Features :
90 5 (12V),110 5 (24V),105 5 (48V)(TSW1:detectonheatsinkofpowertransistor)
90 5 (12V),85 5 (24V),75 5 (48V)(TSW2:detectonheatsinkofo/pdiode)