Datasheet

SPECIFICATION
MODEL
DCVOLTAGE
RATEDCURRENT
CURRENTRANGE
RATEDPOWER
OUTPUT VOLTAGE ADJ.RANGE
LINEREGULATION
LOADREGULATION
SETUP,RISETIME
HOLDUP TIME (Typ.)
VOLTAGERANGE Note.5
FREQUENCY RANGE
EFFICIENCY (Typ.)
INPUT
FUNCTION
INRUSHCURRENT (Typ.)
LEAKAGECURRENT
OVERTEMPERATURE
WORKINGTEMP.
OUTPUTCURRENTTRIM
OUTPUTVOLTAGETRIM Note.6
DCOKSIGNAL
REMOTEON/OFFCONTROL Note.6
AUXILIARY POWER(AUX)
WORKINGHUMIDITY
STORAGETEMP.,HUMIDITY
TEMP.COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVERLOAD
OVERVOLTAGE
ACCURRENT (Typ.)
1000ms,50msatfullload
16ms/230VAC16ms/115VACatfullload
90~264VAC127~370VDC
47~63Hz
5V:5.6A/115VAC2.8A/230VAC12V~48V:8.2A/115VAC3.9A/230VAC
25A/115VAC40A/230VAC
<2.0mA /240VAC
105~125% ratedoutputpower
Protectiontype:Constantcurrentlimiting,recoversautomaticallyafterfaultconditionisremoved
13.8~16.8V5.75~6.75V 17~20.5V 27.6~32.4V 31~36.5V 56.6~66.2V
Protectiontype:Shutdowno/pvoltage,re-powerontorecover
85 5 (TSW2)detectonheatsinkofO/P diode;80 ¢J¡Ó ¢J ¢J¡Ó ¢J 5 (TSW1)detectonheatsinkofpowertransistor
Protectiontype:Shutdowno/pvoltage,recoversautomaticallyaftertemperaturegoesdown
-30~+70 ¢J (Referto"DeratingCurve")
Poweron:shortbetweenon/off(pin13)&12V-AUX(pin14)onCN50Poweroff:openbetweenon/off(pin13)&12-AUX(pin14)onCN50
The TTL signalout,PSUturnon=0~1V;PSUturnoff=3.3~5.6V
Adjustmentofoutputvoltageispossiblebetween40~110%by2~5.5VDCexternalcontrolsignal
Adjustmentofoutputcurrentisbetween40~110% by2~5.5VDCexternalcontrolsignal
12V@0.1A ;tolerance: 10% ¡Ó
20~90%RHnon-condensing
-40~+85 ,10~95%RH ¢J
¡Ó ¢J ¢J 0.03%/ (0~50 )
10~500Hz,2G10min./1cycle,60min.eachalongX, Y,Zaxes
120.8Khrsmin.MIL-HDBK-217F(25 ) ¢J
250*127*41mm(L*W*H)
1.64Kg;6pcs/10.8Kg/1.1CUFT
87%82% 89% 90.5% 90.5% 92%
¡Ó 0.5% ¡Ó 2.0% ¡Ó 0.5% ¡Ó 0.5% ¡Ó 0.5% ¡Ó 0.5%
¡Ó 0.5% ¡Ó 0.5% ¡Ó 0.5% ¡Ó 0.5% ¡Ó 0.5% ¡Ó 0.5%
¡Ó 1.0% ¡Ó 2.0% ¡Ó 1.0% ¡Ó 1.0% ¡Ó 1.0% ¡Ó 1.0%
150mVp-p150mVp-p
10~13.5V4.75~5.5V
150mVp-p
13.5~16.5V
150mVp-p
20~26.4V
150mVp-p
24~30V
150mVp-p
43~55V
12V5V
62.5A100A
0~62.5A0~100A
750W500W
15V
50A
0~50A
750W
24V
31.3A
0~31.3A
751.2W
27V
27.8A
0~27.8A
750.6W
48V
15.7A
0~15.7A
753.6W
RSP-750-12RSP-750-5 RSP-750-15 RSP-750-24 RSP-750-27 RSP-750-48
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
5. Derating may be needed under low input voltages. Please check the derating curve for more details.
6. The power supply unit will have no output if the shorting connector is not assembled. It contains three shorting wires: one is from on/off(pin13) to
12V-AUX(pin14), two is from PC(pin7) to PO(pin8) and the other is from PV(pin5) to PS(pin6). Please refter to function manual for details.
¢J
For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies.
(as available on http://www.meanwell.com)
POWERFACTOR (Typ.) 0.97/230VAC0.98/115VACatfullload
SAFETY STANDARDS
UL60950-1, TUVEN60950-1approved
CompliancetoEN55022(CISPR22), EN61000-3-2,-3
Complianceto EN61000-4-2,3,4,5,6,8,11,EN55024,EN61000-6-2,EN61204-3,heavyindustrylevel,criteria A
750WSingleOutputPowerSupply
RSP-750
se ri es
RIPPLE&NOISE(max.) Note.2
VOLTAGETOLERANCE Note.3
WITHSTANDVOLTAGE
ISOLATIONRESISTANCE
I/P-O/P:3KVACI/P-FG:2KVACO/P-FG:0.5KVAC
I/P-O/P,I/P-FG,O/P-FG:100MOhms/500VDC /25 /70%RH ¢J
ENVIRONMENT
SAFETY &
EMC
(Note4)
PROTECTION
Universal AC input / Full range
AC input active surge current limiting
High efficiency up to 92%
Built-in 12V/0.1A auxiliary power
Built-in active PFC function, PF>0.97
Protections: Short circuit / Overload / Over voltage / Over temperature / Fan
alarm
Output voltage can be trimmed between 40 ~ 110% by 2 ~ 5.5VDC external
control signal
Output current can be trimmed between 40 ~ 110% by 2 ~ 5.5VDC external
control signal
Forced air cooling by built-in DC with fan speed control function
DC OK Signal
Built-in remote ON-OFF control
Built-in remote sense function
3 years warranty
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
High power density 9.44w/inch
1U low profile 41mm
3
¡½
Features :
FileName:RSP-750-SPEC2013-01-04
EMCIMMUNITY
EMCEMISSION