Datasheet

SPECIFICATION
MODEL
DCVOLTAGE
RATEDCURRENT
CURRENTRANGE
RATEDPOWER
OUTPUT VOLTAGE ADJ.RANGE
LINEREGULATION
LOADREGULATION
SETUP,RISETIME
HOLDUP TIME (Typ.)
VOLTAGERANGE Note.5
FREQUENCY RANGE
EFFICIENCY (Typ.)
INPUT
INRUSHCURRENT (Typ.)
LEAKAGECURRENT
OVERTEMPERATURE
WORKINGTEMP.
ALARMSIGNAL OUTPUT
REMOTEON/OFFCONTROL
AUXILIARY POWER(AUX)
WORKINGHUMIDITY
STORAGETEMP.,HUMIDITY
TEMP.COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVERLOAD
OVERVOLTAGE
ACCURRENT (Typ.)
1500ms,100msatfullload
10msatfullload
90~264VAC127~370VDC
47~63Hz
17A/115VAC8A/230VAC
30A/115VAC60A/230VAC
<2.0mA /240VAC
105~135% ratedoutputpower
Protectiontype:Constantcurrentlimiting,recoversautomaticallyafterfaultconditionisremoved
13.8~16.8V
Protectiontype:Shutdowno/pvoltage,re-powerontorecover
105 5 (TSW2)detectonheatsinkofpowertransistor ¢J¡Ó ¢J
Protectiontype:Shutdowno/pvoltage,recoversautomaticallyaftertemperaturegoesdown
-20~+70 ¢J (Referto"DeratingCurve")
PleaseseetheFunctionManual
PleaseseetheFunctionManual
12V@0.1A(OnlyforRemoteON/OFFcontrol)
20~90%RHnon-condensing
-40~+85 ,10~95%RH ¢J
¡Ó ¢J ¢J 0.05%/ (0~50 )
10~500Hz,2G10min./1cycle,60min.eachalongX, Y,Zaxes
109Khrsmin.MIL-HDBK-217F(25 ) ¢J
278*127*83.5mm(L*W*H)
3.0Kg;4pcs/13Kg/1.19CUFT
86.5%
¡Ó 0.5%
¡Ó 0.5%
¡Ó 1.0%
14msatfullload
90%
30~34.8V
16msatfullload
90%
57.6~67.2V
150mVp-p 150mVp-p 200mVp-p
¡Ó 5%typicaladjustmentbyVR,20%~110%(typ.)adjustmentby1~6VDCexternalcontrolsignal
12V 24V 48V
125A 63A 32A
0~125A 0~63A 0~32A
1500W 1512W 1536W
SPV-1500-12 SPV-1500-24 SPV-1500-48
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
5. Derating may be needed under low input voltages. Please check the derating curve for more details.
¢J
For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies.
(as available on http://www.meanwell.com)
FileName:SPV-1500-SPEC2012-06-04
POWERFACTOR (Typ.) 0.95/230VAC0.98/115VACatfullload
SAFETY STANDARDS
UL60950-1, TUVEN60950-1approved
CompliancetoEN55022(CISPR22), EN61000-3-2,-3
Complianceto EN61000-4-2,3,4,5,6,8,11,EN55024,lightindustrylevel,criteria A
RIPPLE&NOISE(max.) Note.2
VOLTAGETOLERANCE Note.3
WITHSTANDVOLTAGE
ISOLATIONRESISTANCE
I/P-O/P:3KVACI/P-FG:2KVACO/P-FG:0.5KVAC
I/P-O/P,I/P-FG,O/P-FG:100MOhms /500VDC/25 /70%RH ¢J
ENVIRONMENT
SAFETY &
FUNCTION
EMC
(Note4)
PROTECTION
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
Universal AC input/Full range
ZVS new technology
AC input active surge current limiting
Built-in active PFC function,PF>0.95
Protections: Short circuit / Overload / Over voltage / Over temperature
Forced air cooling by built-in DC ball bearing fan
High power density 8.3W/inch
Output voltage can be trimmed between 20% ~ 110% rated value
Current sharing up to 4500W(2+1)
Alarm signal output
Built-in 12V/0.1A auxiliary output for remote control
Built-in remote ON-OFF control
Built-in remote sense function
3 years warranty
3
¡½
Features :
1500WSingleOutputPowerSupply
SPV- 1 5 0 0 se ri es
OUTPUTVOLTAGETRIM
..
4.8~28V 9.6~56V
2.4~13.2V
EMCIMMUNITY
EMCEMISSION