User manual

5
SavingMode
ON
SavingMode
OFF
Battery
Battery
Load
Load
Status
Status
Table4-2:LEDIndicationofSavingModeSelection
Note: Theaboveindicationwillbeshowningreen
Light
Dark
Flashing
100Vac
(200Vac)
50Hz
110Vac
(220Vac)
50Hz
115Vac
(230Vac)
50Hz
100Vac
(200Vac)
60Hz
120Vac
(240Vac)
50Hz
120Vac
(240Vac)
60Hz
110Vac
(220Vac)
60Hz
115Vac
(230Vac)
60Hz
Note: Theaboveindicationwillbeshowningreen
Figure4.2:StateCirculationDiagramofOutputVoltageandFrequency
STEP 4: TheLEDswillchangestateeachtimeyoupressthesettingbuttonfor
1 second and then release (refer to Figure 4.2). Please select the
suitablecombinationofoutputvoltageandfrequencyyouneed.
STEP 5: After selecting the output voltage and frequency, press the setting
STEP 6:Pleasereferto Table4-2andcheckwhetherthe"SavingMode"is
STEP 7: TheLEDswillchangestateeachtimeyoupressthesettingbuttonfor
STEP 8: After activating or canceling the "Saving Mode", press the setting
buttonfor3~5secondsandtheinverterwillsendouta"Beep"sound.
alreadysetasyoudesired.Ifyes,pleasejumptoSTEP 8.Ifnot,
1 second and then release. Please activate or cancel the "Saving
Mode"functionasdesired.
buttonforaround5secondsandtheinverterwillsendouta"Beep"
sound. Thebuttoncanbereleasedandallthesettingsarefinished.
The inverter will automatically store all the settings and start to
operate.
startfromSTEP 7.
The button can be released and it goes into the setting section of
"SavingMode".