User manual

EnergySaving
Mode
UPSMode
BatLow
BatLow
Saving
Saving
On
On
Light
Dark
Flashing
Table5.1OperatingMode
Figure5.1: AdjustmentofOutputMode,OutputVoltage,
Frequency,andSavingMode
Useaninsulatedstickto
pressthissettingbutton
ON
ACOUTP UT
SOLARCHARGE
ACCHARGE
OFF
BATT ER Y
100
0
100
0
Savi ng
BatLo w
On
Sett ing
LOAD
INVERTE R
BY PAS SACIN
C
i
r
c
u
i
t
B
r
e
a
k
e
r
P
r
e
s
s
t
o
R
e
s
e
t
Remote
port
10
5.3 Procedure of Setting Operating Mode, Output Voltage, Frequency, and
SavingMode
Note: TS-1500doesnothaveStep3~5.
STEP 1: The inverter should be turned off while resetting. Input batteries
STEP 2:Useaninsulatedsticktopressthesettingbuttonandthenturnonthe
STEP 3: Please refer to Table 5.1 and check the LED status to see if the
STEP 4: The LEDs will change state by pressing the setting button for 1
STEP 5: After selecting the Operating Mode, press the setting button for 3~5
STEP 6: Please refer to Table 5.2 and check whether the combination of
should be connected, AC main can either be connected or
power switch. After pressing for 5 seconds, the inverter will send out
Operating Mode is the one you need. If yes, please skip to STEP 5.
second and then release. Operating Mode can be adjusted as
seconds and the inverter will send out a "Beep" sound. The button
output voltage and frequency is the one you need. If yes, please skip
toSTEP 8.Ifchangeisrequired,pleasefollowSTEP 7~11.
can be released and you can go on to the setting section of
"Voltage/frequency."
required.
Ifchangeisrequired,pleasefollowSTEP 4~11.
a "Beep" sound. Users can release the button and go into the setting
procedure.
disconnected,andtheloadsshouldberemoved.