User manual

12
STEP 10: The LEDs will change state by pressing the setting button for 1
STEP 11: After activating or canceling the "Saving Mode", press the setting
second and then release. You can activate or cancel the "Saving
button for around 5 seconds and the inverter will send out a "Beep"
sound. The button can be released and all the settings are finished.
The inverter will automatically store all the settings and then start
tooperate.
Mode"functionbythisadjustment.
5.4RemoteMonitoringSoftware
6.1InputProtection
(A)Battery Polarity Protection: If the battery input is connected in reverse
(B)BatteryUnderVoltageProtection: Whenthebatteryvoltageislowerthan
(C)Battery Over Voltage Protection: When the battery voltage is too high,
(D)Solar Charger Over Current Protection: The maximum charging current
Please choose suitable batteries that is within the rated input DC
voltage of TN/TS-1500 (refer to the SPEC). If the input DC voltage is
toolow(ex.using12Vdcbatterybankfor24Vdcinputmodels),TN/TS-
1500 can't be started up properly. If the input DC voltage is too high
(ex. using 48Vdc battery bank for 24Vdc input models), TN/TS-1500
WARNING:
will be damaged!
polarity, the internal fuse will blow and the inverter should be send back to
the preset value, the inverter will automatically terminate the output and
inverter will automatically terminate the output and the built-in buzzer will
of the built-in solar charger is 30A. If the charging current is too high, the
internalfusewillblowandtheinvertershouldbesendbacktoMEANWELL
forrepair.
activate to inform the users. Please refer to Table 6.1 for more detail about
thefailuresignalsdisplayedthroughthe"LoadMeter."
"BatteryLow"signalonthefrontpanelwilllightup.Pleasereferto Table6.1
for more detail about the failure signals displayed through the "Load Meter."
MEANWELL forrepair.
(A)Users can also make Operating Mode, voltage/frequency, saving mode,
(B)DB9-USBconversioncableshouldnotbeusedbecauseitwillnotbe
and transition voltage adjustments by using this software. Software update
compatiblewiththemonitoringsoftware.
can be downloaded from the MW website. Please contact us or our
distributorifyouhaveanyquestions.
6.Protection