User Instructions

5
Sav ing Mod e
ON
Sav ing Mod e
OFF
Battery
Battery
Load
Load
Status
Status
Table 4-2 : LED Indication of Saving M ode Selection
Note: T he above indication will be shown in green
●
Light
○
Dark
★
Flashing
●
★
★
★
★
○
100Vac
(200Vac)
50Hz
110Vac
(220 Vac)
50Hz
115Vac
(230Vac)
50Hz
100Vac
(200Vac)
60Hz
120Vac
(240Vac)
50Hz
120Vac
(240 Vac)
60Hz
110Vac
(220Vac)
60Hz
115Vac
(230Vac)
60Hz
Note : The above indication will be shown in gr een
Figure 4 .2: State Circulation Diag ram of O utput Voltage and Frequ ency
STEP 4: The LEDs will change state each time you press the setting button for
1 second and the n release (refer to Figure 4.2). Please select the
suitable comb ination of output voltage and frequency you need.
ST EP 5: After selecting the output voltage and frequency, press the setting
ST EP 6: Please ref er to Tab le 4-2 and check whether the "Saving Mode" i s
STEP 7: The LEDs will change state each time you press the setting button for
ST EP 8: After activating or canceling the "S aving Mode", press the setting
button for 3~5 seconds and the inverter will send out a "Beep" sound.
already set as you desired . If yes, please jump to S TEP 8. If not,
1 second and then rel ease. Please activate or cancel the "Saving
Mode" function as desired.
button for around 5 seconds and the inverter will send out a "Beep"
sound. The button can be released and all the settings are finished.
The inverter will auto maticall y store all the settin gs and start to
operate.
start f rom STEP 7.
The b utton can be released and it goes into the setting section of
"Saving Mode".