Datasheet

ManualsBrandsMEANWELL ManualsIndoor Lighting AccessoriesMean Well LED driver, LED transformer Constant voltage, Constant current 151 W 3.6 A 21 - 42 Vdc dimmable,

WITHSTAND VOLTAGE

ISOLATION RESISTANCE

I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:1.5KVAC

I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃

HLG-150H-12

SPECIFICATION

MODEL

DC VOLTAGE

RATED CURRENT

RATED POWER

OUTPUT

VOLTAGE ADJ. RANGE

Note.6

CURRENT ADJ. RANGE

LINE REGULATION

LOAD REGULATION

SETUP, RISE TIME

Note.8

HOLD UP TIME (Typ.)

VOLTAGE RANGE

Note.5

FREQUENCY RANGE

POWER FACTOR (Typ.)

EFFICIENCY (Typ.)

AC CURRENT (Typ.)

INPUT

INRUSH CURRENT (Typ.)

LEAKAGE CURRENT

SAFETY STANDARDS

Note.7

WORKING TEMP.

WORKING HUMIDITY

STORAGE TEMP., HUMIDITY

TEMP. COEFFICIENT

VIBRATION

MTBF

DIMENSIONOTHERS

NOTE

PACKING

OVER CURRENT

OVER VOLTAGE

OVER TEMPERATURE

Can be adjusted by internal potentiometer A type only

16ms at full load 230VAC / 115VAC

90 ~ 305VAC 127 ~ 431VDC

47 ~ 63Hz

PF>0.98/115VAC, PF>0.95/230VAC, PF>0.92/277VAC at full load (Please refer to "Power Factor Characteristic" curve)

1.7A / 115VAC 0.75A / 230VAC 0.7A / 277VAC

COLD START 65A(twidth=425 s measured at 50% Ipeak) at 230VACμ

<0.75mA / 277VAC

95 ~ 108%

Protection type : Constant current limiting, recovers automatically after fault condition is removed

Compliance to EN55015, EN55022 (CISPR22) Class B, EN61000-3-2 Class C ( 60% load) ; EN61000-3-3≧

Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, EN55024, light industry level (surge 4KV), criteria A

-40 ~ +70 (Refer to "Derating Curve")℃

20 ~ 95% RH non-condensing

-40 ~ +80 , 10 ~ 95% RH℃

±℃ ℃0.03%/ (0 ~ 50 )

10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes

192.2Khrs min. MIL-HDBK-217F (25 )℃

228*68*38.8mm

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance : includes set up tolerance, line regulation and load regulation.

4. Please refer to "DRIVING METHODS OF LED MODULE".

5. Derating may be needed under low input voltages. Please check the static characteristics for more details.

6. A type only.

7. Safety and EMC design refer to EN60598-1, subject 8750(UL), CNS15233, GB7000.1, FCC part18.

8. Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of the set up time.

9. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the

complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.

10. Refer to warranty statement.

11. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used behind a switch without permanently

connected to the mains.

1.15Kg; 12pcs/14.8Kg/0.74CUFT

150W Single Output Switching Power Supply

•

Universal AC input / Full range (up to 305VAC)

•Built-in active PFC function

•High efficiency up to 94%

•Protections: Short circuit / Over current / Over voltage / Over temperature

•Cooling by free air convection

•OCP point adjustable through output cable or internal potentiometer

•IP67 / IP65 design for indoor or outdoor installations

•Three in one dimming function (1~10Vdc or PWM signal or resistance)

•Suitable for LED lighting and street lighting applications

•Compliance to worldwide safety regulations for lighting

•Suitable for dry / damp / wet locations

•5 years warranty (Note.10)

■

Features :

HLG-150H series

RIPPLE & NOISE (max.) Note.2

VOLTAGE TOLERANCE

Note.3

ENVIRONMENT

SAFETY &

EMC

PROTECTION

Shut down o/p voltage, recovers automatically after temperature goes down

14 ~ 17V 18 ~ 21V

23 ~ 27V

28 ~ 34V

34 ~ 38V

41 ~ 46V 54 ~ 63V

47 ~ 53V 59 ~ 65V

91.5%

92%

93%

93.5%

94%94% 94%

±2.5% ±2.0% ±1.0% ±1.0% ±1.0%

±1.0%

±0.5% ±0.5% ±0.5% ±0.5% ±0.5%

±0.5%

±2.0%

±1.5% ±1.0% ±0.5% ±0.5%

±0.5%

±1.0%

±0.5%

±1.0%

±0.5%

HLG-150H-12

HLG-150H-15

HLG-150H-20

HLG-150H-24

HLG-150H-30

HLG-150H-36

HLG-150H-48

12V 15V 20V 24V 30V

36V

48V

150mVp-p 150mVp-p

13.5 ~ 17V

150mVp-p

17 ~ 22V

150mVp-p

22 ~ 27V

200mVp-p

27 ~ 33V

200mVp-p

33 ~ 40V

200mVp-p

43 ~ 53V10.8 ~ 13.5V

HLG-150H-54

54V

200mVp-p

49 ~ 58V

HLG-150H-42

42V

200mVp-p

38 ~ 46V

7.5 ~ 12.5A 6 ~ 10A 4.5 ~ 7.5A 3.8 ~ 6.3A 3 ~ 5A

2.5 ~ 4.2A

1.92 ~ 3.2A 1.68 ~ 2.8A

2.16 ~ 3.6A

12.5A 10A 7.5A 6.3A

4.2A

3.2A

150W 150W 150W 151.2W 150W

151.2W

153.6W

2.8A

151.2W

3.6A

151.2W

FMM

110

SELV

IP65 IP67

A : IP65 rated. Output voltage and constant current level can be adjusted through internal potentiometer.

B : IP67 rated. Constant current level adjustable through output cable with 1~10Vdc or 10V PWM signal or resistance.

Blank : IP67 rated. Cable for I/O connection.

SHORT CIRCUIT

Constant current limiting, recovers automatically after fault condition is removed

Protection type : Shut down o/p voltage with auto-recovery or re-power on to recovery

D (option, safety pending) : IP67 rated. Timer dimming function, contact MEAN WELL for details.

EMC IMMUNITY

EMC EMISSION

UL8750, CSA C22.2 No. 250.0-08, EN61347-1, EN61347-2-13 independent IP65 or IP67, J61347-1, J61347-2-13 approved ;

design refer to UL60950-1, TUV EN60950-1

THD< 20% when output loading 60% at 115VAC/230VAC input and output loading 75% at 277VAC input≧≧

TOTAL HARMONIC DISTORTION

1000ms,50ms/115VAC 500ms,50ms/230VAC at full load ; B type 1000ms,200ms/115VAC 500ms,200ms/230VAC at 95% load

CONSTANT CURRENT REGION

Note.4

6 ~12V 7.5 ~ 15V 10 ~ 20V 12 ~ 24V 15 ~ 30V

18 ~ 36V

24 ~ 48V 27 ~ 54V

21 ~ 42V

Summary of content (6 pages)

PAGE 1
HLG-150H 150W Single Output Switching Power Supply series ■ Features : •Universal AC input / Full range (up to 305VAC) •Built-in active PFC function •High efficiency up to 94% •Protections: Short circuit / Over current / Over voltage / Over temperature •Cooling by free air convection •OCP point adjustable through output cable or internal potentiometer •IP67 / IP65 design for indoor or outdoor installations •Three in one dimming function (1~10Vdc or PWM signal or resistance) •Suitable for LED lighting an
PAGE 2
HLG-150H 150W Single Output Switching Power Supply Mechanical Specification Case No.954D series Unit:mm Blank:(HLG-150H) 228 204 12 9.4 9.6 34.2 T case 68 300±20 FG (Green/Yellow) AC/L(Brown) AC/N(Blue) 102 300±20 9.4 34 SJTW 18AWG×3C SJTW 14AWG×2C ψ4.2×4PL -V(Black) +V(Red) 38.8 ※ T case: Max. Case Temperature. ※IP67 rated. Cable for I/O connection. A Type:(HLG-150H-_A) 228 204 12 9.4 9.6 34.2 Vo ADJ. T case 68 300±20 FG (Green/Yellow) AC/L(Brown) AC/N(Blue) Io ADJ.
PAGE 3
HLG-150H 150W Single Output Switching Power Supply series D Type(option):(HLG-150H-_D) 228 204 12 9.4 9.6 34.2 T case 102 68 300±20 FG (Green/Yellow) AC/L(Brown) AC/N(Blue) 300±20 9.4 34 SJTW 18AWG×3C -V(Black) +V(Red) SJTW 14AWG×2C ψ4.2×4PL 38.8 ※ T case: Max. Case Temperature. ※ IP67 rated. Timer dimming function, contact MEAN WELL for details. Block Diagram Fosc : 100KHz EMI FILTER & RECTIFIERS I/P RECTIFIERS & FILTER POWER SWITCHING PFC CIRCUIT +V -V DIM+ DIM(B Type) O.L.P.
PAGE 4
HLG-150H 150W Single Output Switching Power Supply series Power Factor Characteristic Constant Current Mode PF 1 .0 0 0 .9 8 0 .9 6 0 .9 4 0 .9 2 0 .9 0 0 .8 8 0 .8 6 0 .8 4 0 .8 2 0 .8 0 0 .7 8 2 7 7 V ac 2 3 0 V ac 1 1 5 V ac 50% 60% 70% 80% 90% 100% (150W) LOAD EFFICIENCY vs LOAD (48V Model) HLG-150H series possess superior working efficiency that up to 94% can be reached in field applications.
PAGE 5
HLG-150H 150W Single Output Switching Power Supply series DIMMING OPERATION(for B-type only) FG (Green/Yellow) AC/L(Brown) AC/N(Blue) DIM+(Blue) DIM-(White) HLG-150H -V(Black) +V(Red) ※ Built-in 3 in 1 dimming function, IP67 rated. Output constant current level can be adjusted through output cable by connecting a resistance or 1 ~ 10Vdc or 10V PWM signal between DIM+ and DIM-. ※ Please DO NOT connect "DIM-" to "-V".
PAGE 6
HLG-150H 150W Single Output Switching Power Supply series WATERPROOF CONNECTION ◎ Waterproof connector Waterproof connector can be assembled on the output cable of HLG-150H to operate in dry/wet/damp or outdoor environment. AC source HLG-150H I/P Size O/P Size Pin Configuration (Female) M12 Order No. Suitable Current 4-PIN 5A/PIN M12-04 10A max. Pin Configuration (Female) M15 5-PIN 5A/PIN M12-05 10A max. 2-PIN 12A/PIN M15-02 12A max. Order No.