User manual

BatLow
BatLow
Saving
Saving
On
On
Table5.3LEDIndicationforSavingModeON/OFF
Light
Dark
Flashing
Figure5.2:StateCirculationDiagramofOutputVoltageandFrequency
Table5.2:LEDIndicationofOutputVoltage/FrequencyCombination
50Hz
60Hz
100Vac 110Vac 115Vac 120Vac
(200Vac)
On
On
Light
Dark
BatLow
BatLow
Saving
Saving
Flashing
(220Vac) (230Vac) (240Vac)
Output
Voltage
Frequency
100Vac
(200Vac)
50Hz
110Vac
(220Vac)
50Hz
115Vac
(230Vac)
50Hz
100Vac
(200Vac)
60Hz
120Vac
(240Vac)
50Hz
120Vac
(240Vac)
60Hz
110Vac
(220Vac)
60Hz
115Vac
(230Vac)
60Hz
SavingMode
ON
SavingMode
OFF
11
STEP 7: The LEDs will change state by pressing the setting button for 1
secondandthenrelease(refertoFigure5.2).Pleaseselectthe
combinationofoutputvoltageandfrequencyyouneed.
STEP 8: After selecting the output voltage and frequency, press the setting
STEP 9: Please refer to Table 5.3 and check whether the "Saving Mode" is set
button for 3~5 seconds and the inverter will send out a "Beep"
as required. If yes, please skip to STEP 11. If change is required,
pleasefollowSTEP 10~11.
sound. The button can be released and it will go into the setting
sectionfor"SavingMode."