User`s guide

PCI-2513 User's Guide Installing the PCI-2513
12
6834
1 35
34
1
68
35
Figure 2. CA-68-3S and CA-68-6S cable
Field wiring and signal termination
You can use the following MCC screw terminal boards to terminate field signals and route them into the
PCI-2513 board using the CA-68-3R, CA-68-3S, or CA-68-6S cable:
 TB-100: Termination board with screw terminals.
 RM-TB-100: 19-inch rack mount kit for the TB-100 termination board.
Details on these products are available on our web site at
www.mccdaq.com/products/screw_terminal_bnc.aspx#.
Installing multiple boards
PCI-2513 features can be replicated up to four times, as up to four boards can be installed in a single host PC.
The serial number on each PCI-2513 distinguishes one from another. You can operate multiple PCI-2513
boards synchronously. To do this, set up one PCI-2513 with the pacer pin you want to use (XAPCR or XDPCR)
configured for output. Set up the PCI-2513 boards you want to synchronize to this board with the pacer pin you
want to use (XAPCR or XDPCR) configured for input. Wire the pacer pin configured for output to each of the
pacer input pins that you want to synchronize.