SDS

Mechanic In a Bottle Hydraulic Oil Fix
Conforms to OSHA CFR 29 1910.1200 and aligns to the United Nations Globally Harmonized System
Page 4 of 9
5.4 Fire Fighting Equipment/Instructions: Firefighters should wear full-face, self-contained breathing
apparatus and impervious protective clothing. Firefighters should avoid inhaling any combustion products.
Section 6 - Accidental Release Measures
6.1 Spill /Leak Procedures: Ventilate area. Wear adequate protective equipment.
6.2 Spills: Avoid direct contact with the material. Stop leak if without risk. Move containers from the spill area.
Prevent entry into sewers or waterways. Contain and collect spillage with non-combustible, absorbent material
such as sand, earth, vermiculite, or diatomaceous earth and place it in a container for disposal.
Section 7 - Handling and Storage
7.1 Handling Precautions: Do not take them internally. Prevent eating, drinking, tobacco use, and cosmetic
application in areas with potential exposure to the material. Avoid contact with eyes, skin, and clothing. Avoid
inhalation of dust or vapor. Wear appropriate chemical protective clothing and equipment. Always wash
thoroughly after handling.
7.2 Storage Requirements: Store in the original manufacture container tightly closed in a cool, dry, and well-
ventilated area.
7.3 Chemical Incompatibilities: Strong oxidizing agents and strong acids.
Section 8 - Exposure Controls / Personal Protection
8.1
Chemical Names
ACGIH- TLV
OSHA - PEL
1H-Imidazole-1-ethanol, 4,5-
dihydro-, 2-nortall-oil alkyl derivs.
None Shown
None Shown
8.2
ACGIH® = American Conference of Governmental Industrial Hygienists. TLV® = Threshold Limit Value.
OSHA = US Occupational Safety and Health Administration. PEL = Permissible Exposure Limits.
NOTE: TWA Means "TWA is the employee's average airborne exposure in any 8-hour work shift of a 40-hour
work week which shall not be exceeded."
8.3 Ventilation: Provide a general or local exhaust ventilation system to maintain airborne concentrations
below TLV/PELs Local exhaust ventilation is preferred because it prevents contaminant dispersion into the
work area by controlling it at its source.
8.4 Contaminated Equipment: Separate contaminated work clothes from street clothes and launder them
before reuse. Remove this material from your shoes and clean personal protective equipment.
8.5 Personal protective equipment
Respiratory protection
Where risk assessment shows that air-purifying respirators are appropriate, use a full-face respirator with multi-
purpose combination respirator cartridges as a backup to engineering controls. If the respirator is the sole means
of protection, use a full-face supplied air respirator. Use respirators and components tested and approved under
appropriate government standards such as NIOSH (US).