Service manual

6-27WPM Drive Systems Manual

BBC Cable Removal (Recycler/Rear Bagger)

Fig 199 3428-0192

9. Start the shaft into the hole in the housing. Rotate

the idler/brake arm clockwise so the upper tab on

the spring can engage the boss in the housing.

Rotate the idler/spring arm counterclockwise (Fig.

199) and push the rest of the way into the housing.

The brake pad should now ride on the brake drum.

Fig 198 3428-0190

8. Slip the spring over the shaft. One tang of the spring

must engage the tab as shown (Fig. 198).

BBC / BOS / BCS

10. Hold the idler/brake arm in place. Slip the spring

over the end on top of the deck as shown. Install

the lever and install the screw through the lever and

idler/brake arm shaft (Fig. 200). Once the screw is

secured take a loop of wire or rope and hook the end

of the spring. Pull it towards you and hook the end

as shown.

Fig 200 3428-0177-3

1. Loosen the cable clamp and pull cable out from

under the screw (Fig. 201).

Fig 201 3428-0172

A. Idler/brake arm

A. Spring C. Wire loop

B. Screwdriver