Service manual

7-12 WPM Drive Systems Manual
HANDLES AND CONTROL CABLES
Fig 254 DSC-4899a
3. Slide the pivot assembly, bail and the brake cable to
the right until the bail slides off the pin (Fig. 254).
4. Continue sliding the pivot assembly and brake cable
off the pin.
5. Remove the shoulder bolt that the traction lever
pivots on and remove the traction lever.
6. Pull the pin out of the left hand handle. Note it
is snapped in and will require a locking pliers or
something similar to remove. When removed, the
springs will push the handle upwards (Fig. 255).
Fig 255 DSC-4907a
A
B
A. Traction lever C. Top slide
B. Pivot assembly
2. Remove the e-clip on the left side pivot pin (Fig.
253).
Fig 253 DSC-4896a
C
A
A
A. E-clip