Service manual

1-10 WPM Drive Systems Manual
WORM DRIVE TRANSMISSION
Fig 021 3428-0127
The transmission cable is a standard lever type. Since
the spring and pin on top of the transmission pushes the
shift fork towards the engaged position, the cable pulls
the shift arm to the rear to disengage the transmission.
The adjustment point is on the mower housing just to
the rear of the transmission. To adjust, pull the control to
the rear (disengage). Go to the cable clamp/adjustment.
Loosen the clamp, pull the cable to the rear until the shift
lever is as far back as it will go. Hold it there and tighten
the clamp (Fig. 021).
Adjustment
A
A. Cable Clamp