Service manual

3-23WPM Drive Systems Manual
SINGLE SPEED BEVEL GEAR TRANSMISSION
Fig 103 PICT-1926
15. Remove the nut, washer, 2 pulley halves, and
spacer from the transmission input shaft. Remove 2
screws securing the belt guide to the transmission
(Fig. 103).
Fig 102 MVC-211x1
A. 2 screws on top D. Pulley half
of transmission E. Washer
B. Spacer F. Nut
C. Pulley half
A
A
B
B
C
C
D
D
E
E
F
F
16. Push the transmission to the left, as shown, and
rotate to clear the tunnel. Drop the left side down,
then pull the assembly out to the left side (Fig. 104).
Fig 104 MVC-300
17. The last step is to slide the bearings and bearing
retainers off the axle (Fig. 105).
Fig 105 MVC-301